RONDA T2 Movement Holder Instructions
- June 7, 2024
- RONDA
Table of Contents
RONDA T2 Movement Holder
Product Information
Specifications
- Model: H21X.1T
- Movement Holder: H71X.1A
- Caliber: 215
- Date Switching Time : ~ 1 1/4 hours
Product Usage Instructions
Removing Setting Stem
To remove the setting stem, ensure the movement holder is in position I.
Carefully detach the setting stem using the appropriate tools as per the
product manual.
Setting Hands
When setting hands, utilize the movement holder H71X.1A for precision. Make
sure to use supporting screws during the hand-mounting process for stability
and accuracy.
Fitting Dial and Hand
Follow the instructions provided in the manual for fitting the dial and
hands correctly. This step is crucial for the proper functioning of the
product.
Date Switching Time
The date switching time for this product is approximately 1 1/4 hours.
Ensure to adjust the time accordingly to trigger the date change at the
desired time.
Permitted Hand Setting Forces
When setting the hour, minute, or second hand, apply appropriate force as
specified in the manual to prevent damage to the product.
FAQ
-
Can I remove the setting stem in any position?
No, the setting stem can only be removed in position I as mentioned in the general instructions. -
Why is it important to use supporting screws when mounting hands?
Supporting screws provide stability and ensure accurate hand placement, preventing potential damage to the product.
OTHER VARIENTS
Fitting dial and hand
- Crown in position III
- Wind hour hand forward, until date changes
- Remove working hand
- Put friction spring 3315.020 on the hour wheel
- Fit dial
- Set every hand towards 12 o‘clock
- Set time
- Pull crown in position II
- Set calendar function
- Push crown in position I
General instructions
-
Removing the setting stem can only be effected in position I.
-
The use of supporting screws is essential when mounting the hands.
-
Permitted hand setting forces: Hr. / min. / second hand: <40N / <40N / <30N
-
During quick date correction (setting stem in position II), a date switching speed of 5 d/s must not be exceeded.
-
This movement contains a rechargeable battery that is charged via the solar cell. Only batteries specified by RONDA may be used. Under no circumstances may a silver oxide battery or any other conventional watch battery be used.
-
A LED is built in as overvoltage protection. This lights up as soon as the battery cannot absorb all the energy of the solar cell or no battery is inserted.
Attention:- The movement is equipped with a solar cell on the dial side. Careful handling is therefore essential. Scratches or contact with any liquids can cause irreparable damage to the solar cell.
- Direct pressure on the plastic ring as well as on the electronics attached to it must be avoided. This can impair or damage the solar function.