emerio HD-105697.2 Hair Dryer Instruction Manual

June 6, 2024
emerio

emerio logo

emerio HD-105697.2 Hair Dryer

emerio HD-105697.2 Hair Dryer

Before use make sure to read all of the below instructions in order to avoid injury or damage, and to get the best results from the appliance. Make sure to keep this manual in a safe place. If you give or transfer this appliance to someone else make sure to also include this manual. In case of damage caused by user failing to follow the instructions in this manual the warranty will be void. The manufacturer/importer accepts no liability for damages caused by failure to follow the manual, a negligent use or use not in accordance with the requirements of this manual.

SAFTY

  1. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

  2. Children shall not play with the appliance.

  3. Cleaning and user maintenance shall not be made by children without supervision.

  4. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

  5. WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.

  6. When the hairdryer is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the hairdryer is switched off.
    For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.

  7. Before inserting the plug into the mains socket, please check that the mains voltage and frequency comply with the specifications on the rating label.

  8. Disconnect the mains plug from the socket when the appliance is not in use and before cleaning.

  9. Ensure that the mains cable is not hung over sharp edges and keep it away from hot objects and open flames.

  10. Do not immerse the appliance or the mains plug in water or other liquids. There is danger to life due to electric shock!

  11. To remove the plug from the plug socket, pull the plug. Do not pull the power cord.

  12. Do not touch the appliance if it falls into water. Remove the plug from its socket, turn off the appliance and send it to an authorized service centre for repair.

  13. Do not plug or unplug the appliance from the electrical outlet with a wet hand.

  14. Never attempt to open the housing of the appliance, or to repair the appliance yourself. This could cause electric shock.

  15. Never leave the appliance unattended during use.

  16. This appliance is not designed for commercial use.

  17. Do not use the appliance for other than intended use.

  18. Do not wind the cord around the appliance and do not bend it.

  19. Keep the device and the cable away from heat, direct sunlight, moisture, sharp edges and suchlike.

  20. Never use the device unsupervised!Switch off the device whenever you are not using it, even if this is only for a moment.

  21. Do not spray aerosol products when the hair dryer is in operation.

  22. Use only original accessories.

  23. Do not use the device outdoors.

PARTS IDENTIFICATION

emerio HD-105697.2 Hair Dryer fig1

  1. Concentrator nozzle
  2. Air intake grille
  3. Cool shot button
  4. 2 speed settings
  5. 3 heat settings
  6. Hanging loop

COMMISSIONING

  1. Fully unwind the mains cable.

  2. Attach a nozzle.
    Using the hairdressing nozzle, individual sections of the hair can be dried selectively by bundling the air flow.
    Curly hair can be ideally dried using the diffuser.

  3. Insert the plug into the contact socket.

HOW TO USE THE HAIRDRYER

emerio HD-105697.2 Hair Dryer fig2

select the desired speed setting or to switch off the appliance, push the switch along the handle. Do the same to select the desired temperature. To select the cool shot function, put the speed selector to the setting normal or fast and keep the cool shot button pressed.

Cool shot:
With this switch it is possible to interrupt the heating process so that the air can be mixed according to individual requirements.

CLEANING AND CARE

  • Ensure that hair dryer is disconnected from the mains supply before cleaning.
  • Never immerse the hair dryer in water and always ensure that plug is kept dry.
  • Clean the air suction opening from time to time with a fine brush. Clean the housing with a soft, dry cloth without additives.
  • Frequently clean out any hair or fluff that becomes stuck in the inlet filter. To clean the filter, vacuum or dry clean, never immerse the filter in water. Failure to keep filter clean may result in overheating.
  • This appliance conforms with CE directives for radio interference suppression and low-voltage safety and has been built to meet current safety requirements. Subject to technical changes without prior notice!

TECHNICAL DATA

Operating voltage: 220-240V ˜ 50-6 0Hz
Power: 2200W

RECYCLING

This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE).
This means that this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentially dangerous for the environment and human heath due to the presence of hazardous substances.

QUALITY
Safety and quality is very important to HEMA. We have our own laboratory, which assesses all equipment in terms of electrical safety and ease of use, before it is included in our range. HEMA also monitors the product quality in collaboration with the manufacturer.

SECURITY
This HEMA item may be fitted with a plastic anti-theft strip. You will find the strip on the bottom of the product. This strip does not influence the quality or the operation of the product and can be removed without a problem.

FAULTS AND REPAIRS

If this device needs to be repaired, you can hand it in at a HEMA branch after packing the product securely. Do not try to repair this product yourself. For repairs that fall within the warranty period, you will need to show a proof of purchase and the warranty document. Regularly check the power cord for damage. If there is any damage to the cord set, please return the item to a HEMA branch for repair. Do not try to replace it yourself. For safety reasons we recommend that you do not carry out any repairs to an electrical device yourself.

WARRANTY

The warranty period is 2 years from the date of purchase. Always keep your receipt in a safe place. It’s handy if you take a picture of the receipt and save it somewhere. Then you will always have an easy-to-read receipt in your possession.

WARRANTY CONDITIONS
HEMA quality guarantee
HEMA guarantees that the product you have purchased meets the standards our customers are entitled to expect in terms of quality and product properties. These warranty conditions do not affect your statutory or consumer rights and apply in all countries where there are HEMA branches.
Warranty claims
If you wish to make a warranty claim, please return the product with proof of purchase to one of our stores. The store will determine whether to replace the product (with an identical or equivalent product), accept the product for repair within a reasonable period of time or refund the price of the product.

Invalidation of warranty
The warranty on this article is invalidated if the fault or defect is caused by:

  1. normal wear and tear
  2. external damage (for example, damage caused by exposure to sand or moisture or due to falling of the product, etc.)
  3. improper or inappropriate use
  4. overdue or incorrect maintenance, including repairs that were not authorised by HEMA
    The above list does not exclude other possible reasons for defects not being covered by the warranty.

Added confidence when choosing a HEMA product
You may swap or return the product within 30 days after purchase (provided it is undamaged and you have proof of purchase).
1 November 2019
HEMA BV
PO Box 37110
1030 AC Amsterdam
The Netherlands
These warranty conditions apply without prejudice to the customer’s statutory rights or any other claims by the customer.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals