V-TAC VT-700 LED Spotlight Fitting Instruction Manual
- June 6, 2024
- V TAC
Table of Contents
WEEE Number: 80133970
INSTALLATION INSTRUCTION
Model: VT-700
SPOTLIGHT FITTING
INTRODUCTION
Thank you for selecting and buying V-TAC LED Spotlight Fitting. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any other queries, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at your best.
INSTALLATION INSTRUCTION
- Switch off the power.
- Ensure that the void depth is a minimum of 90mm, the thickness of the ceiling is a maximum of 20mm. (Picture 1)
- Cut a hole using an appropriate tool according to the cut-out. (Picture 2)
- When opening the package, take out the fixture and install the GU lamp as step 3.
- Connect the wire of the driver to mains (110V-220V) in a correct way and put the driver into the ceiling properly. (Picture 4)
- Push the spring clips upwards and fit into the ceiling hole (Picture 5), ensuring the product is sitting properly in the hole.
- Switch on the power if the above steps are done properly without mistakes.
WARRANTY
- This product is a warranty from manufacturing defects only.
- The warranty is valid for 2 years from the date of purchase.
-
- The warranty does not apply to damage caused by the installation or abnormal wear and tear.
- The company gives no warranty against damage to any surface due to incorrect removal and installation of the product.
In case of any query/issue with the product, please reach out to us at: support@v-tac.eu For More products range, inquiry please contact our distributor or nearest dealers. V-TAC EUROPE LTD. Bulgaria, Plovdiv 4000, bul.L.Karavelow 9B
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>