CoreStar CS63038 BT Module BT5.0 Embedded System On Chip Module User Manual
- June 6, 2024
- CoreStar
Table of Contents
CoreStar CS63038 BT Module BT5.0 Embedded System On Chip Module User Manual
This document contains confidential and proprietary information of CORESTARCo., Ltd and shall not be duplicated or otherwise transferred to a third party without the express written consent of CORESTAR.
Hardware overview
Main Board PCB Physical Specifications
Connector Definitions
J1 CTRL CON
Pin No.| DESCRIPTION| Pin No| DESCRIPTION| Pin No.| DESCRIPTION| Pin No.|
DESCRIPTION
---|---|---|---|---|---|---|---
1| +5V| 2| GND| 3| HV_RXD| 4HV_TXD|
5| REV| | | | | |
Operational description
The Conter Power Board provides power to the Upper Board, which supplies power to the BT Module
Mobile phone open Fitness_Sole APP search BT Module device use。
Operating frequency : 2402 ~ 2480MHz
Modulation: GFSK
PCB antenna / 0dbi
IC WARING STATEMENT
Canada, Industry Canada (IC) Notices
CAN ICES-003(B) / NMB-003(B)
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of
the device.
Canada, avis d’Industry Canada (IC)
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Industry Canada
(IC) radio frequency exposure limits. The Wireless Device should be used in
such a manner such that the potential for human contact during normal
operation is minimized.
FCC WARING STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference and
(2)this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
Information to OEM integrator
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user manual of the
end product. The user manual which is provided by OEM integrators for end
users must include the following information in a prominent location.
- Only those antennas with same type and lesser gain filed under this FCC ID number can be used with this device.
- The regulatory label on the final system must include the statement: “Contains FCC ID: 2ANCG-CS63038 “
- The final system integrator must ensure there is no instruction provided in the user manual or customer documentation indicating how to install or remove the transmitter module except such device has implemented two-ways authentication between module and the host system.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>