Dong Guan Shi Chang Jia Yuan Dian Zi Ke Ji You Xian Gong Si KG1201-A Wireless Remote Switch Instruction Manual
Table of Contents
Dong Guan Shi Chang Jia Yuan Dian Zi Ke Ji You Xian Gong Si KG1201-A
Wireless Remote Switch
KG1201-A Operating instructions
If you want to control your water pump and dust collector by KG1201-A, you need to pair the switch to your transmitter first.
- How to clean code: press the pairing button 8 times, light flashes, cleaning code completely
- How to set working mode:
Power on the switch first
-
Momentary mode: Press the “pairing button” one time fast, red led light on, then press the transmitter button, red LED blinks fast, then off. (press remote button, switch on; release button, switch off)
-
Toggle: Press the “pairing button” 2 times fast, red led light on, then press the transmitter button, red light blinks fast, then off. (press remote button, switch on; press again, switch off)
-
Latched mode: Press the “pairing button” 3 times fast, red led light on, then press the transmitter button A, red light blinks fast; then press button B, red light blinks fast, then off. (press remote button A, switch on; press button B, switch off)
-
10 seconds countdown: Press the “pairing button” 4 times fast, red led light on, then press the transmitter button, red light blinks fast, then off. (press remote button, switch on, after 10 seconds it will be off)
-
30 seconds countdown: Press the “pairing button” 5 times fast, red led light on, then press the transmitter button, red light blinks fast, then off. (press remote button, switch on, after 30 seconds it will be off)
90 seconds countdown: Press the “pairing button” 6 times fast, red led light on, then press the transmitter button, red light blinks fast, then off. (press remote button, switch on, after 90 seconds it will be off) -
120 seconds countdown: Press the “pairing button” 7 times fast, red led light on, then press the transmitter button, red light blinks fast, then off. (press remote button, switch on, after 120 seconds it will be off)
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- — Reorient or relocate the receiving antenna.
- — Increase the separation between the equipment and receiver.
- — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- — Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
The devices have been evaluated to meet general RF exposure requirements， the device can be used in portable exposure conditions without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>