Dong Guan Shi Chang Jia Yuan Dian Zi Ke Ji You Xian Gong Si WiFi 30A Wireless Remote Switch Instruction Manual
Table of Contents
WiFi 30A Operating instructions
If you want to control your water pump and dust collector by WiFi 30A, you need to pair the switch to your transmitter first.
- How to clean code: press the pairing button 8 times, light flashes, cleaning code completely
- How to set working mode:
Power on the switch first
-
Momentary mode: Press the “pairing button” 4 times fast, red led light on, then press the transmitter button, red light blinks fast, then off.
(press remote button, switch on; release button, switch off) -
Toggle: Press the “pairing button” 2 times fast, red led light on, then press the transmitter button, The red light blinks fast, then off. (press remote button, switch on; press again, switch off)
-
Latched mode: Press the “pairing button” 3 times fast, red led light on, then press the transmitter button A, red light blinks fast, then press button B, red light blinks fast, then off. (press remote button A, switch on; press button B, switch off)
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
The devices have been evaluated to meet general RF exposure requirements， the
device can be used in portable exposure conditions without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>