Dongguan Tyjin Electronics C-128A Wireless Charging User Manual
- June 6, 2024
- Dongguan Tyjin Electronics
Table of Contents
Dongguan Tyjin Electronics C-128A Wireless Charging User Manual
FRONT
BACK
NORMAL & FAST WIRELESS CHARGING
PLEASE MAKE SURE TO USE A WALL ADAPTER OR USB PORT THAT IS 1A – 2.4A 2.4A
CHARGERS WILL ENABLE FAST CHARGE FUNCTION. DO NOT USE ANY USB PORTS BELOW 1A
(EX: COMPUTERS OR USB PORTS THAT ARE BELOW 1A.)
TROUBLESHOOTING
IF YOU HAVE PROBLEMS WITH WIRELESS CHARGING MAKE SURE YOUR PHONE IS CENTERED ON CHARGER.
GET TO KNOW YOUR CHARGER
- SINGLE-COIL QI WIRELESS CHARGER
- INDUCTIVE CHARGING
- CHARGING INDICATOR LED
- DESIGNED FOR QI COMPLIANCE
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CAUTION:
approved by the party responsible for compliance could void the user’s authority to operate this device.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
FCC Warning
** This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note:** This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>