Dongguan Tyjin Electronics C-098A Wireless Charging Pad User Manual
- June 5, 2024
- Dongguan Tyjin Electronics
Table of Contents
C-098A Wireless Charging Pad
User Manual
COMPATIBILITY
iPhoneX，iPhone•xs iPhoneXS Max,iPhone® XR, iPhon@8 Plus, iPhone@8
Samsung Galaxy S10, Galaxy S10+ Galaxy S10e, Galaxy S9, & Note 8
INPUT: 5V2A, 9Vt.67A
OUTPUT: 5W/7.5W/10W
FOR MAX CHARGING SPEED USE Quick Charge adapter WILL ONLY CHARGE THROUGH CASES SMM THICK OR LESS
FAST WIRELESS CHARGING
PLEASE MAKE SURE TO USE A WALL ADAPTER OR USB PORT THAT IS quick charge
GET TO KNOW YOUR KNOWLEDGE
- SINGLE-COIL QI WIRELESS CHARGER
- INDUCTIVE CHARGING
- CHARGING INDICATOR LED
- DESIGNED FOR QI COMPLIANCE
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an : uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
TROUBLESHOOTING
IF YOU HAVE PROBLEMS WITH WIRELESS CHARGING MAKE SURE YOUR PHONE IS CENTERED ON CHARGER
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.