Coscaaco BH591A Beans F1 True Wireless Earbuds User Manual
- June 6, 2024
- Coscaaco
Table of Contents
Beans Fl
RUE WIRELESS EAPSUDS User Manual
PACKING LIST
DIAGRAM
POWER ON
- The earphones automatically turn on(with white LED light flashing) and start pairing when you open the charging case.
- In the shutdown status and when the earphones are not in the charging case. simultaneously press and hold the MFB of both earbuds for 2 seconds to power on ( with the white LED light flashing).
POWER OFF
- Put the earphones back in the charging case and close the case to turn them off.
- If the earphones are not in the charging case. just press and hold the MFB of both earbuds for 5 seconds to power them off (Mode 2 cannot be conducted during music playing or calling.)
PAIRING
- Open the charging case. they will automatically enter the pairing mode in which the LED light flashes white and red alternately. and then select ‘Beans F1’.
Note The earbud will reconnect to the paired device by priority. If you want to pair to the second smartphone. please disconnect Bluetooth on the paired smartphone.
MUSIC
-
Volume Up / Down
Volume+: press and hold the MFB button of the Right earbud to turn up the volume increasingly.
Volume -: press and hold the MFB button of the Left earbud to turn down the volume decreasingly.
-
Next / Previous Track
Next Thick double touch the MFB of the Right earbud. Previous Track double touches the MFB of the Left earbud. -
Play/Pause
Touch the MFB of either earbud once.
INCOMING CALL
-
Answer / Hang
Up to Double touch the MFB of either earbud. -
Reject
Press and hold the MFB of either earbud for 1 second -
Activate Siri
Triple-touch the MFB of either earbud.
RESET
In the state of charging. simultaneously press and hold the MFB of both earbuds for 5 seconds. The LED light will flash red, which means that the paired information is cleared successfully
CHARGING
Do not put the earbuds in the charging case when the earbuds are wet
CORRECT DISPOSAL OF THIS PRODUCT
( Waste Electrical& Electronic Equipment )
This Marking showed on the product or its hteratureindicate that it should not
be disposed with other household wastes at the end of its working life. To
prevent possible harm to the environment or human health from uncontrolled
waste disposal. please separate this from other types of waste and recycle it
responsibly to promote the sustainable reuse of material resources. Household
users should contact either the retailer where they purchased this product or
their local government office. for details of where and how they can take this
item for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contact This product should not be mixed with other
commercial wastes for disposal.
FCC STATEMENT
My Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment
NOTE This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules These
limits are designed to provide reasonable protection against harmful
interference in a residential installation This equipment generates uses and
can radiate radio frequency energy and if not installed and used in accordance
with the instructions may cause harmful interference to radio communications
However, there is no guarantee that interference will not occur in a
particular installation If this equipment does cause harmful interference to
radio or television reception. which can be determined by turning the
equipment off and on the user is encouraged to try to correct the interference
by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions (1 ) This device may not cause harmful interference. and (2) this device must accept any interference received. including interference that may cause undesired operation FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>