niceboy NCB050C4A Hive Pods 2 Wireless Headphones User Manual
- June 6, 2024
- niceboy
Table of Contents
niceboy NCB050C4A Hive Pods 2 Wireless Headphones
PACKAGE CONTENTS:
- Niceboy HIVE pods 2 headphones
- Charging box
- Backup earphone attachment
- Micro USB-B cable
- Manual
PRODUCT DESCRIPTION
- Multifunctional button
- LED diode
- Charger input
- LED charging indicator
- Charging micro USB-B port
INITIAL START UP AND PAIRING
- Take both headphones out of the charging box and take off the labels protecting the charging pins (3) on the headphones.
- Power on the headphones with one long press of the multifunctional button (3) on both headphones.
- After the LED diode (2) begins to flash both green and red, the headphones are prepared to connect to a Bluetooth device.
- Open the Bluetooth settings on your own device and search for “Niceboy HIVE pods 2” on the list of available devices.
- Once the pairing is successful it will be announced by an audible queue and the LED diode (2) will flash green for a long interval.
Just take the headphones out of the box to connect them again to a previously connected device. The headphones will automatically power on and connect to the device.
POWERING ON AND OFF:
Just take the headphones out of the charging box to power them on or ma-nually
power on the headphones with one long press of both multifunctional buttons.
To power the headphones off, just place them back in their charging box. They
will power off themselves and disconnect from your device. The diode (2) will
shine red once the headphones have been correctly stored in their box. If the
headphones are 100% charged, the diode will stop shining. The headphones can
also be powered off with one long press of both multifunctional buttons
lasting about 6 seconds.
MULTIFUNCTIONAL BUTTON – BASIC CONTROLS
One press of any – play / pause, answer / end call
Press the right button twice to increase the volume by one level
Press the left button twice to decrease the volume by one level
Long press of right button – next track, reject call
Long press left button – previous track, reject call
CHARGING:
To charge the charging box itself, connect the charging cable to the USB port (5). The diode (4) flashes when charging and stops flashing once full battery has been reached.
FACTORY SETTINGS
Place both headphones in the box and hold down both of their multifunctional buttons until the diode flashes red three times. Once you take the headphones out of the box, they will have been restored to their factory settings.
SPECIFICATIONS
- Bluetooth: 5.0
- Supported Bluetooth profiles: HFP, HSP,A2DP, AVRCP
- Degree of protection: IPX5
- Transmission range: 10m
- Frequency: 20Hz-15kHz
- Sensitivity: 94db ± 3dB
- Speaker: 6mm
- Playback time: up to 6.5 hours
- Headphone battery capacity: 70mAh
- Charging box battery capacity: 500mAh
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>