Quanzhou Longtuo Electronic Technology TDM6 Two-Way Radio User Manual
- June 6, 2024
- Quanzhou Longtuo Electronic Technology
Table of Contents
Quanzhou Longtuo Electronic Technology TDM6 Two-Way Radio User Manual
Functions
- TOT
- Battery Saving
- Low Battery Warning
- SQL
- Frequency Hoping
Technical Specs
| Frequency range | FRS |
|---|---|
| Voltage | DC 3.7V |
| Channel No. | 22 channels |
| Antenna Impedance | 50Ω |
| Operate Mode | Simplex or Semi-duplex |
| Size | 50x15x130mm(including the antenna) |
Instruction
Power ON/OFF
- POWER ON: Rotate the knob clockwise to turn on the radio, and use the same knob to adjust
- POWER OFF: Rotate the knob counterclockwise to power off
Function key
- Press PTT to talk.
- Press key No. 2 to increase the channel, press long time to monitor function.
- Press key No. 3 to decrease the channel, press long time to torch
Light color features
- Light color will be green every 7 or 8 seconds when power standby.
- Light color will be red when transmit.
- Light color will be green when receive.
Low battery warning
Low battery will remind you to recharge or change new battery.
If there is no enough power, it will remind you please change or charge the battery every 15 seconds.
switch Chinese or English
Make it in channel No. 15, reboot when press key NO.3 to switch Chinese or English.
Re programme by software
TOT is to avoid someone occupy one channel for long time, you could set the value by software ( it could be 15 second, 30 second, to 600 second, range is every 15 second). It will stop transmitting if your time is over TOT value, you have to redo it again.
Frequency hopping
Every channel has the frequency hopping function, to protect your privacy through encryption.(note: both parties should choose ON in frequency hopping setting)
FCC Compliance Statements
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. Do not use this device when the antenna shows obvious damages.
Hold this transmitter approximately 25 mm away from your face and speak normal with the antenna pointed up and away. Use the supplied belt clip for body-worn configuration as other accessories may not comply to the limits.