Xiamen Hanin Electronic Technology M11 Portable Pocket Label Printer User Guide
- June 6, 2024
- Xiamen Hanin Electronic Technology
Table of Contents
Xiamen Hanin Electronic Technology M11 Portable Pocket Label Printer
Product Introduction
Appearance and Components
Packing List
Printer
|
USB Cable
|
Quick Start Guide
---|---|---
Product Introduction
LED Indicator Status
Button Operation
- Hold down the power button for a few seconds: Turn on/off the printer
- Press the power button: Position and calibrate the location of thermal label paper and heating line
Paper Loading
App Download
Scan the QR code to download App.
Connection and Printing
-
Turn on Bluetooth on your mobile phone, then open App, click “Device Connection”, select “ HPRT M11”.
-
Select “Scan to get the template”, then scan the QR code on the paper core to recharge consumables mileage and get the templates.
-
Edit the label as need, and then click “Print” after editing.
Battery Charging
When the battery power is low, the red LED indicator will flash slowly.
Please charge it by the exclusive USB cable in time. If you continue printing，
it may power off automatically.
| Note: The printer can be charged via computer USB port or AC adapter. Please
note that the AC adapter is not supplied.
---|---
General Q&A
When the printer crashes, how to deal with it?
Open the upper cover, lightly hold down the [Reset] button with a pin so that
the printer will be off, and then restart the printer.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
FCC ID：2AUTE-PLP
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>