petwant W3 Pet Water Fountain User Manual

petwant W3 Pet Water Fountain

Product Glance

Assemble Your Fountain

1. Place the pump in designed location as the figure.
   

2. Add water as needed. Water le -vel should be always above the “MIN” water line indicated on the main body.
   

3. Place the filter in the basin and install the top cover.
   

4. Make sure your hands and plugs are dry before plug in the fountain.
   

Fountain Specifications

Pump Cleaning

1. Take out the pump sponge.
   

2. Squeeze on either side of the intake plate and pull off.
   

3. Remove the stator by placing your finger nail under the small lip.
   

4. Lift the impeller and clean it.

Important Safety Instruction

1. When the device is not in use, the power should be turned off.
2. The power should be turned off while cleaning the base. Ensure that it is fully dry before use.
3. Make sure the water level in the tank is between the “MIN” and “MAX” water line which is marked inside the main body.
4. When the water level is below the “MIN” , the device will stop to work. Add water to restart the device.
5. Replace the Purification Filter every two to four weeks.
6. Excess impurities on the filter will reduce water quality and lower the water penetration speed. We recommend cleaning the filters each time you clean the device.
7. Resin the filter throughly under cool water before placing into the filter area. Rinsing will remove a majority of the loose charcoal dust.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>