petwant F14-L Automatic Pet Feeder User Manual

petwant F14-L Automatic Pet Feeder User Manual

Features

• Main Body

• Food Hopper

• Food Bowl

• Stainless Steel Bowl

• Power Adapter

• Desiccant

• Manual
  

Setup and Assemble Feeder

Lift The Latch
Take out the food hopper and install it by aligning the slot on the base.

Place Desiccant
Open the desiccant box on top lid, tear off the transparent wrapping paper of the desiccant bag, place it into the box and close it

Plug in Power Adapter

1. Battery power supply: remove the battery cover by releasing the retaining clip, insert 3 good quality alkaline “D” batteries and reinstall the battery cover.
2. Power adapter supply: plug in the power adapter and connect the power cable into the card slot.

Install Food Bowl
Tilt the base unit back slightly, align the buckle of the food bowl with the base unitto install; the same steps to disassemble.

Grain Size Self-check:

Fill Pet Food (Unit:mm)
Open the top lid, pour fresh dry food into the food hopper, and close the top lid.

“Note : The device only s ort 5-12mm dry pet food

Product Introduction

Unlock The Panel

Long press “( )” button for 5 seconds to unlock, 30 seconds no operation screen will be automatically locked

Set Clock

1. Unlock the panel, Press “( )” button to enter setting,
2. set Clock: Press “( )” or “()” toads’ tours, Press “( )” button to confirm. Press “( )” or “( )” to adjust minutes Press “( )” button to confirm.

Program Feeding Schedule

1. Program Meal Time: “ 1 ” icon flash means setting the first meal, Press “( )” or “( )” to adjust hours and minutes, Press “(@)” button to confirm.
2. Meal Size: LCD display goes into meal size set mode after setting the meal time “ ” icon illuminate, Press “( )” or “( )” to select desired, Press “( )” button to confirm.
3. Repeat this process for as meal times portions desired (Up to 4 meals and 9 portions)
4. If you do not need to set too much feeding schedule, long press the “( )” button to save and exit the set mode.

Check the feeding schedule

In the locked state, press “( )” or “( )” to check the 1-4 meal feeding schedule, but it cannot be set.

Manual Feed

Unlock the parcel, long press “( )” button to feed one.

Record

Unlock the panel, long press ( )” to enter recording mode, the “STATE” indicator lightis on
and record voice toward the “MIC” hole for up to 10 seconds. If the * ( )” button is released with
in 10 seconds, the recording ends immediately.

Note: If you need to record again repeat the above steps.

Play Record

Unlock the panel, press * ( )” to play record once, no play if no record.

Cancel Feeding Schedule

Seethe portion to be “promin: then no feed anymore.

Default Meal Settings

Unlock the panel and presser * ( )” and “( )” simultaneously until heard “DIDI” sound, which resettle time and clears the feeding schedule and recording,

Indicator Information

Tate

| ON| Working
---|---|---
STATE| ON| Voice Recording
Flash| Device Faulty
Low Battery Power

LCD Screen Icons Information

| OFF| Battery Uninstaffed
---|---|---
ON| With Battery Inside
| ON| Low Battery Power
| ON| Panel Unlock
| ON| Panel Lock
MEAL: 1 234| OFF| Meal OFF
ON| Meal ON
FLASH| Meal Seting

Disassemble & Clean

Power Off
Unplug and take out the alkaline batteries.

Clean

1. old the fuselage steady and pull out the food hopper upward. 1
2. Disassemble the impeller and feeding mechanism.
3. The main body of the feeder is nat dish washer-safe. Do notimmerse the main body in water. This could damage the internal electronics and cause the batteries to short out, create an electrical shock, or catch fire.
4. Use the dry soft cloth to wipe it, the body is not waterproof, please do not use wet cloth
5. Make sure all parts of the feeder are completely clean and dry before filling with food

Assemble

1. Align the triangle mark when installing the impeller E
2. Install the food hopper by aligning the soot on the base.

Replace the desiccant pack
Open the desiccant box cover and replace the desiccant. It is suggested to replace it every one manths.

Replace Alkaline Batteries
Unplug and open battery i at the bottorn, then you can replace the batteries

“Warmings:

1. Please keep the food hopper dry after cleaning it.
2. Please replace the food on a regular basis if your pets did not eat up. Please clean and maintenance your device on a regular basis to prolong the using period of your pet feeder.

batteries
Feeder faulty| Contact After-sale service
Impeller can not be installed| Food blocked on the installation position| Clear the cat food inside the installation position, align the triangle and reinstall
Food hopper can not be installed| Food blocked on the installation position| Clear the cat food inside the installation position and reinstall
E1 — Display| Impurities inside food hopper| Clean the impurities inside of food hopper
Food size inapplicable| Ensure to use 5—12mm dry food

Parameters

Safety Precautions

Read allinstructions carefully before attempting to operate this device.

Keep Device

1. For indoor use ONLY.
2. Device need to be placed horizontally and firmly, it’s not allowed to tipped one side and rock or upside down.
3. Keep device placed in a dry area and not expose the device under sunlight.
4. Not to place the feeder in a high place to avoid the damage from dropping.
5. DONOT place any foreign objects i the feeder,
6. .To avoid tripping, always keep power cord out of the way of foot traffic
7. Do not place anything on top of this feeder.
8. Ensure there s no barters near the food outlet o make the pes can be fed normally

Electricity safety

1. Please check the power supply before going out.
2. The clock will be maintained for a year i the device is powered off.
3. Please pay attention o the battery display when powered by batteries, users need to replace the batteries when ” shows on LCD screen
4. I’s suggested to replace the batteries once a year if you do not get the device work by batteries, for the power will be running off with time goes by.
5. when powered by batteries, tis normal for the electric quantity icon to fluctuate occasionally because of the large transient current.
6. To prevent electric shack, do not insert the power cord or plug into water or other equids.
7. The device only supports the use of a 5v/14 adapter; please do not use a non-specific adapter.

Caution

1. Intended for use with dogs or cats ONLY.
2. DO NOT use this feeder with puppies, kittens, dogs or cats with any physical disability.
3. NOT recommended for puppies or kitens less than 7 months old or unable to reach the feeding dish.
4. DO NOT allow small children ta play with, in or around feeder.
5. DO NOT eat the desiccant. DO NOT use it if it is damaged.
6. For oy food use ONLY. Works best with 5-12mm food diameter or smaller
7. DO NOT attempt any repairs or modifications to the feeder.
8. DO NOT immerse the feeder in water at any time, as this can cause damage to the electronic components.
9. Dispose of all packaging material property. Some items may be packed i oly bags; these bags could cause suffocation; keep away from both children and pets.
10. Check with your veterinarian if you are unsure about the proper MEAL SIZE for your pet
11. DO NOT operate feeder without Bowl, Food Hopper and Lid securely in place.

Please read the manual carefully before using this product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>