Shantou Create Toys Industrial 8031 Remote Control Stunt Car Instruction Manual
- June 6, 2024
- Shantou Create Toys Industrial
Table of Contents
Shantou Create Toys Industrial 8031 Remote Control Stunt Car
Contents
Preparation
Use a &erewdrvier 10 to loose the screw on battery cover of transmitter by counter-clockwise, take out tho battery cover according to arrow direction.
USB charging
Operation
The function of transmitted( buttons:
- Press the forward and backward buttons. then can use rt, the Indicator light on the transmitter will light up when press the button.(The Indicator fight of the transmitter will light up wtion press any button of controUer).
- When pressing the forward/backward button, the car goes forward/backward.
- Press the button of turn left/tum right while the car is going torwerdlbacl\Ward, then the car will make left right turn.
cautions
- The car body with 2.4V Li-ion rechargeable battery,transmitter with 2*1.5V AA batteries
- Batteries are to be inserted with the correct polarity;
- Non-rechargeable batteries are not to be recharged;
- Rechargeable batteries are only to be charged under adult supervision;
- Different types of batteries or new and used batteries are not to be mixed;
- The supply terminals are not to be short-circuited;
- The car is with powerful power, when the car in high speed,please do not brake suddenly because of inertia cause;
- When the speed slows down, it means that there is not enough electricity in the car body,please charge the car;
- When the controller power shortage.match frequency light will darken or off,please change the battery of transmitter;
- Please identify the charging jack and charging port when charging;
- Please use the correct USB charger.otherwise will damage the product;
- Please take batteries out from the transmitter when it’s not in use for a long time.and turn power switch to “OFF”;
- Unpacking shall be carried out under the guidance of adults ;
- The packaging has to be kept since it contains important information.
FCC Rules
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: ( 1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>