Zhongshan Letspro Audio Visual Equipment YK-77T Plastic Tripod User Manual
- June 6, 2024
- Zhongshan Letspro Audio Visual Equipment
Table of Contents
USER MANUAL
About the wireless connection
- Turn on the remote control switch, the blue light will flash and enter into a pairing state.
- Turn on your phone(iPhone/Android), search for the “LY-11” device, and connect it.
- After the pairing is successful, turn on the camera of your phone, and press the button to take photos. Enjoy it.
Important:
No operation more than 2 munites, the remote will go into a sleep state to save power, is not defective, please return it on by switching the switch. It will automatically connect to your phone.
How to use this selfie stick tripod
- Adjust the tripod leg up and down, fix the tripod leg by rotating the screw clockwise
- Quick flick locks design, convenient to lock/unlock the stick and keep it tight. DO NOT
- Rotate the screw too tight or remove the holder or platform.
- Loosen the screw counterclockwise, select the appropriate angle. then tighten the screw clockwise to fix the selfie stick platform head.
Cellphone Assemble instruction
Notice: the remote shutter only works for smartphones, not for cameras
HOW TO EXPAND THE LEGS
- rotating the screw counterclockwise to loosen the legs.
- Use your fingers to push out 3 legs at the same time just like the picture shows
WARNING
This is designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
The devices have been evaluated to meet general RF exposure requirements, the device can be used in portable exposure conditions without restriction.