Ailun 36335047 Selfie Stick Tripod User Manual
- June 6, 2024
- Ailun
Table of Contents
Ailun 36335047 Selfie Stick Tripod User Manual
1 Product Introduction
2 Remote controller separation / charging
Take out remote controller take out the remote controller from the bottom of
the remote controller
Install the remote controller I first fix the Top of the remote controller, 1.
press clown into the remote controller
Switch on and off
Fix the mobile phone to the mobile phone bracket, press the camera button for 2 seconds long until the green light flashes, Bluetooth pairing mode is on; Turn on the Bluetooth settings on the mobile phone, search for and connect to the “Ailun Stick” then the green light is constant on; press the camera button on selfie stick for taking pictures.
4 No recognized text !
Firstly: palm hold the Shutter Button end of the product handle bar with one hand,lightly fingertip push open the tripod legs outward at the opposite triangle opening end of the stick.
Secondly: with one hand hold the Shutter Button position,pull the phone bracket end out, adjust it to the required length
Note: when pulling out the pull pole, the bottom tripod leg will open auto matically at the same time, please do not open the bottom tripod leg forcibly with your hand,avoiding to cause product damage.
5 Put away the tripod
Hold the middle of the selfie stick by one hand, and push the pull pole back into the handle bar one by one.
Note: when pushing the pull pole, the tripod will be closed automatically. Please do not put your hand directly on the tripod leg to prevent clamping injury,
6 Horizontal vertical screen switching
The product uses the patent of sliding rail for mobile phone bracket to reserve rotating space, it can achieve horizontal vertical screen free switching without moving the mobile phone.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be u sed in portable exposure condition without restriction FCC ID:
2A4KI-01
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>