SUMMIT SUTV-2020 UTV Dual 1080p Camera System Installation Guide

SUMMIT SUTV-2020 UTV Dual 1080p Camera System

Instructions

Kit Contents

Camera Installation

Mounting hardware installation

1. Remove the 4 Allen screws that are located on the sides of the camera and remove the camera mounting bracket and visor.
2. Find an appropriate place to mount the camera. Line up the foot bracket to ensure that there is enough space to attach the camera to the body.
3. Attach the mounting foot using either selftapping screws or a bolt and nut.
4. Use a 1” hole saw to drill a hole for the camera harness`

Camera Mounting

1. Feed the harness through the drilled hole, fit the grommet to the inside of the hole.
2. Reattach camera and visor to the mounting bracket. Make sure the camera is oriented UP by seeing the light sensor on the right side of the camera when looking at it.
3. Route the camera harness to where the diplay is located.
4. Connect the 4-pin to RCA cable to the end of the harness at the display end. (This wont be needed anymore, all connections are 4 pin)

Monitor Installation and Wiring

Roll Bar Mount

1. Choose the proper size roll bar mounting ring.
2. Use supplied foam and apply to the inner ring of the bracket.
3. Place mounting ring on desired location. A fair amount of force might be necessary.
4. Attach the neck of the mounting bracket to the mounting ring, and tighten the cross bolt. a). Note: If there is still movement in monitor bracket mount, lay 1 to 2 strips of electrical tape between the roll bar and the bracket base.

Vehicle Wiring

1. Connect the RED to 12-volt accessory.
2. Connect the BLACK to ground.
3. Connect YELLOW to 12-volt constant power.

Camera Wiring

1. Connect the GREEN wire to select parking.
2. Connect the White
3. The BLACK connector is for the power plug.
4. to turn off the guidelines  connect the white wire loop on the camera harness.

FAQ Section

1. How do I stop the monitor mount from moving on the roll cage?
   We recommend adding a strip of electrical tape to the mounting plate in order to create a tighter fit.

2. How do I turn off the monitor?
   Hold down the power button for 3 seconds.

3. Is the monitor waterproof?
   The cameras are rated for IP 69K, however the montior is not waterproof. We recommend mounting it high on the roll bar to prevent the possibility of submerging the unit.

4. What type of battery does the remote use?
   The remote uses a 2032 3V battery..

WARNING
Cancer and Reproductive Harm www.P65Warnings.ca.gov

References

• P65Warnings.ca.gov
• Smartsheet.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>