SUMMIT FFUF194IM 33 Wide Upright All Freezer with Ice Maker User Guide
- May 15, 2024
- SUMMIT
Table of Contents
QUICK START GUIDE
FFUF194IM 33 Wide Upright All Freezer with Ice Maker
WATER LINE CONNECTION FOR INSTALLED (MODULAR) ICEMAKERS
NOTES:
-
This manual provides instructions on how to connect a water line to an icemaker already installed on your Summit freezer/refrigerator-freezer (RIM469). Please read the manual carefully and follow the instructions exactly as described, observing all safety instructions.
-
A certain amount of mechanical ability is required to complete the water connection process.
WARNING: Connect to potable water supply only. -
You will have to purchase a ¼” OD copper tubing kit. The kit contains all the hardware necessary to connect your icemaker to the water supply, including the regular valve (NOTE: valve should only be installed in a cold-water supply). You can purchase one at most hardware or plumbing supply stores.
-
DO NOT USE PIERCING-TYPE OR 3/16” SHUT-OFF VALVES. They reduce the flow of water to the icemaker and are easily clogged.
-
The icemaker (RIM469) is installed only by the manufacturer or a qualified service agent. CUSTOMER INSTALLATION IS NOT WARRANTED BY THE APPLIANCE OR ICEMAKER MANUFACTURER.
FORMING THE COPPER TUBING:
Loop the copper tubing coming from the water valve as shown. Position the coiled copper tubing near the center of the unit so that it forms an “accordion-fold” (as shown in the diagram below) for when the refrigerator is moved to and from the wall.
STARTING THE ICEMAKER
Wash out the ice bucket. Slide it under the icemaker (see diagram below) as
far as it will go. The ice bucket will be sitting on top of the freezer shelf.
Lower the arm on the icemaker (as shown in the diagram) to its “on” position
and close the freezer door. (NOTE: If your icemaker has an on/off switch,
toggle to the “on” position.) The icemaker will begin to make ice within 24
hours. NOTE:
It usually takes approximately 24 hours for the icemaker to begin producing
ice. Once ice is available, you may notice that it has an “off” taste. If this
happens, make two or three batches of ice and discard them. After that, the
“off” taste should be gone.
TROUBLESHOOTING
Operational Notes:
The icemaker water valve contains a flow washer that acts like a pressure
regulator to control the water flow. For the icemaker to work properly, the
water pressure in your home must be between 20 and 120 pound-per-square-inch
(psi). If you encounter problems with your icemaker’s ability to produce ice,
call your water utility company and have the water pressure checked.
The icemaker’s water valve is equipped with two strainers: a plastic basket
type and a wire mesh screen. Both of these can be cleaned by turning off the
water and disassembling the water valve (your service center should be able to
provide this service). If local water conditions require periodic cleaning, or
if you use a well as a water source, you should consider installing a second
water strainer in the water line. You can obtain a water strainer from your
local appliance dealer.
The chart below lists several common problems that may occur with your
icemaker.
| PROBLEM | CAUSE/SOLUTION |
|---|
One or more of the following sounds is heard:
– Buzzing
– Trickling water
– Thud (clatter of ice)| -The water valve is operating.
-Water is entering the icemaker to fill cup.
-Ice is being dumped into the ice bin.
Ice tastes stale| The ice is old. Make a new batch.
Water in icemaker overflows| Refrigerator or icemaker is not level. If the
icemaker still overflows after leveling, turn off
the icemaker’s water supply at the shut-off valve and raise the icemaker’s
bail arm to the “off” position (see previous page); then contact your local
service center.
Not enough ice| It will take 48 hours to fill the ice bucket. The icemaker
will make ice every 2 to 3 hours. For more ice, adjust the freezer control to
a colder setting.
Ice making has stopped| Be sure that the bail arm is lowered into the ice
bucket. Make sure that the water shut-off valve is open. The water shut-off
valve or the water valve screen is clogged. Contact your local service center.
Summit Appliance, Div. of Felix Storch, Inc.
Bronx, NY 10474
Tel: 718-893-3900
Fax: 844-478-8799
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>