MONNIT 3P-QSG-01 150 Amp Three Phase Current Meter User Guide
- June 6, 2024
- MONNIT
Table of Contents
Quick Start Guide for the 20 / 100 / 150 Amp Three-Phase Current Meter
Remove your sensor from the package and install the antenna.
Open iMonnit and verify the sensor is checking in and reporting data. Verify
the sensor has a full battery level.
If you don’t see the sensor checking in, press the button on the gateway and
power cycle the sensor. Create or log in to your iMonnit account
and register your sensor. Find the device ID on the label and click “Add
Device”.
Next, power the sensor on and verify it checks into iMonnit.
We recommend powering the sensor on near the gateway then moving to the
installation location, checking signal strength along the way.
NOTE
The CTs are designed to clip around a single current-carrying wire. Ensure
that the CT is NOT wrapped around a cable with a common and live wire
otherwise, the sensor will read approximately 0.00 amps. See the diagram below
for appropriate CT installation.
For more information on this Monnit product, click this link:
https://www.monnit.com/support/MonnitCorporation
3400 South West Temple Salt Lake City, UT
84115801-561-5555
www.monnit.com
Monnit, iMonnit and all other trademarks are property of Monnit,
Corp. © 2020 Monnit Corp. All Rights Reserved.
3P-QSG-01 (07/20)
References
- Remote Monitoring Solutions with Wireless Sensors for IoT
- Wireless Three-Phase Current Meters | 20, 150, and 500 Amp
- Monnit Support Options: FAQs, Knowledgebase, Videos, Docs, & More
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>