SOLTECH Cegonia 8W-20W and 30w Elegant Solar LED Light Instruction Manual

SOLTECH Cegonia 8W-20W and 30w Elegant Solar LED Light

Introduction

Thank you for purchasing CEGONIA Urban Lighting Products.

Introduction
CEGONIA combines stylish design with high efficiency. You can adjust both the tilt angle and the azimuth to make sure the panel is in the optimal position to capture the sun’s energy. It is a perfect fit for courtyards, parks, schools, communities, and paths.

Important
In order to avoid deep discharge of the battery during storage, please fully recharge your battery every 4 months. Please make sure that the light is installed in an area with sufficient sunlight irradiance. A strict minimum of 3.5 hours/day of sunshine on average is recommended. Select the right operating mode according to the local legislation needs and the local sunshine conditions. Keep it away from shadows. Self-cleaning is available when the light fixture has a minimum angle of 15 degrees.
Please save these instructions. Read all of the instructions carefully before attempting to carry out any installation or wiring. Do not open or attempt to repair the product on your own, as it many cause serious damage and would void the product warranty. Contact your local distributor for any questions concerning the installation.

Range of the light module on the lighting fixture is 20–26 feet
(6–8 meters). The ideal installation spacing is >16 feet(5 meters). When installing two or more lighting fixtures on one pole, select desired operating mode before installation. Interference can cause delay or malfunction when using the remote control to change operating modes after installation.

Precautions when working with solar panels
When the solar panel is exposed to sunlight, a voltage appears at the output terminals of the solar panel turning it into a source of electricity. To avoid a shock hazard, make sure the solar panel is covered with an opaque (dark) later such as paper or cloth during the installation. Do not make contact with the terminals when the panel is exposed to sunlight or any other light source .

Specification

30AH
Weight| 15.9Lbs| 34.6Lbs| 40.4Lbs
Lumen Output@5000K| 1600| 4000| 6000
CRI| > 70| (> 80 Optional)| > 70| (> 80 Optional)| > 70| (> 80 Optional)
LED Chip| Lumileds 5050 (215lm-CR>70)| Lumileds 5050 (215lm-CR>70)| Lumileds 5050 (215lm-CR>70)
EPA| 2.37 ft2| 6.12 ft2| 6.12 ft2
Waterproof Rate| IP65| IP65| IP65
Casting| Aluminum| Aluminum| Aluminum
Efficiency@5000K| 200lm/W| 200lm/W| 200lm/W
*** Charging Time| 6hrs| 6hrs| 6hrs
Operation Mode**| Remote control and

One-key Setting

| Remote control and

One-key Setting

| Remote control and

One-key Setting

Installation Height| 6–13 ft| 9–16 ft| 9–20 ft
Operating Temperature| -4 to 122˚F| -4 to 122˚F| -4 to 122˚F
Charging Temperature| 32 ˚F to 149 ˚F| 32 ˚F to 149 ˚F| 32 ˚F to 149 ˚F

Maximum Autonomy@Full Power

Motion Sensor Mode

|

40%–100% 35hrs

20%–80% 55hrs

|

40%–100% 35hrs

20%–80% 55hrs

|

40%–100% 35hrs

20%–80% 55hrs

Time Control Mode

|

Night Owl 28hrs

Early Bird 25hrs

|

Night Owl 28hrs

Early Bird 25hrs

|

Night Owl 28hrs

Early Bird 25hrs

Constant Mode

| 100% 12hrs

70% 17hrs

40% 30hrs

| 100% 11hrs

70% 15.5hrs

40% 27hrs

| 100% 11hrs

70% 15.5hrs

40% 27hrs

Luminous Distribution

CEGONIA 8W Type III

CEGONIA 20W Type III

CEGONIA 30W Type III

Battery Notes

1. The LiFePO4 -battery-powered CEGONIA lights are visibly brighter than other outdoor solar lights, and their performance overall is more reliable.
2. To charge the battery fully may take up 6 to 12 hours.
3. Output will be reduced to 40% when the battery is below 40% of its capacity.
4. Battery will stop charging when the ambient temperature is below 32°F or above 149°F.

Battery Status is indicated by the red/green indicator on the lighting fixture as follows:

• Red indicator (Charging)
• Slow red light flashing = Charging
• Red light continuously on = fully charged
• Quick red flashing = charge fault
• Green indicator (not charging)
• Green light continuously on = more than 40% of the battery capacity remaining
• Slow green light flashing = battery capacity below 10%
• Quick green light flashing = battery below 0% mode—Protect battery does not over discharging

Storage
To avoid over discharge of the battery during storage, please recharge the lighting fixture every 4 months. Use the dedicated charger to charge, reset the switch when done.

Battery Replacement

1. Disconnect the wire connectors.
2. Loose the screws of the battey pack and take out the battey pack.
3. Replace a new one.
4. Tighten the screws of battery pack.
5. Connect the wire connectors

(Be sure you match the color when you connect them).

(IAP) Intelligent Adaptive Program Battery Control Technology
In order to extend the off-grid autonomy of the CEGONIA under shady trees, heavy rain, and thick clouds, our controllers now integrate an adaptive smart control feature to actively track battery capacity and adjust light output accordingly. Before integrating this feature, selecting a light output percent-age on the remote would yield an accurate percentage of max LED brightness. Now with (IAP), the controller actively monitors the battery and regulates the electrical current to the LEDs. The controller makes light output of the selected percentage on the remote relative to battery capacity rather than max LED output. This smart-control feature can increase our off- grid performance by up to 40%.

Installation and Wiring Compliance

1. Installation and wiring must comply with the State and National Electrical Codes.
2. The CEGONIA 8W, 20W and 30W models are intended for outdoor use only and should not be installed in an unventilated area, and shall be installed in an environment within the operational temperatures defined for the product.
3. The average sunshine in the installation area should be above 3.5 hours/day in order to ensure full function of the lighting fixture. Avoid areas with shades.
4. Before installation, if applicable, please ensure the light pole and its foundation are solid enough to withstand the lighting fixture(s).
5. Before installation, please ensure that the battery is fully charged. Install during sunny days if possible.
6. Before installation, please press the ON/OFF key in the remote control and check whether it shows a red light on the indicator. Please cover the panel and check if the light module turns on normally within 1 minute.

After Installation
The lighting fixture will automatically turn on at night and turn off during daylight.

Important
Always orient the solar panel facing the equator (e.g. facing south if in northern hemisphere).
Always have a tilt angle of at least 15° to avoid dust accumulation (0°=horizontal plane).

Ordering Information Chart

Series| Wattage| Color

Temperature

| Mounting Options| Finish
---|---|---|---|---

TLSTE =CEGONIA

|

8 =8W 1600 Lumens

|

3 =3000K

|

WM =Wall Mount

|

WH =White

 | 20 =20W 4000 Lumens| 4 =4000K| TRR =Trunnion Round|
 | 30 =30W 6000 Lumens| 5 =5000K| TRS =Trunnion Square|
 |  | 6 =5700K|  |

Mounting Accessories

Installation

CEGONIA 8W

CEGONIA 20W 30W

Panel Angle

The Solar charge in a battery pack won’t last forever, the off–grid system relies on stored daylight for autonomy. Angling your solar panels properly can boost the power intake of your lights. You want to angle your solar panels at a tilt equal to the area’s latitude.

Tip
You can increase the tilt 15° in the winter or decrease 15° in the summer. In this way you can get the maximum sunlight to recharge the battrey bank.
The area will dictate the installation of the fixtures and will sometimes prevent the lights from facing south. But that’s okay! Panels facing West & East won’t get as much light as Southern facing panels, but will still collect a good amount of sunlight. A North facing panel also works, but it will take longer to charge than any other direction. This would mean that the solar charge will be less optimal if installations are facing North.

Remote Control Guide

The range of the remote control to the indicator is 16ft (Day time) to 33ft (Night time). Because the sunlight will impact the signal of the remote control, we recom-mend that users setup the mode before they install the light.

1. On/Off
   When off is selected, the light will stop working. The solar panel will not charge the battery and the battery will not supply electricity to the light.

2. Connect/Test
   Remote control device can be connected with any lighting fixture, one at a time. To connect, press the button once. It also functions as a test button. To test, press the “Test” button once, the red light will indicate the fixture is charging, green light indicates that the fixture is operating. Testing lasts for 10 seconds, and then it goes back to the mode previously in use.

3. 40%~100% Motion Sensor Mode
   Constant 40% brightness (turns on at dusk, turns off at dawn); 100% brightness turns on for 2 minutes when motion is detected.

4. 20%~80% Motion Sensor Mode (Default)
   Constant 20% brightness (turns on at dusk, turns off at dawn); 80% brightness turns on for 2 minutes when motionis detected.

5. Night Owl Mode
   Changes as natural light decreases/increases (turns on at dusk); 70% brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, 50% brightness for 1 hour, 20% brightness for 5 hours (turns off at Dawn ).

6. Early Bird Mode
   Changes as natural light decreases/increases with increased brightness near dawn for early risers (turns on at dusk); 70% brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, 50%brightness for 1 hour, 20% brightness for 4 hours, 100% brightness for 1 hour (turns off at Dawn ). (IAP) Intelligent Adaptive Program Battery Control Technology
   In order to extend the off-grid autonomy of the CEGONIA under shady trees, heavy rain, and thick clouds, our controllers now integrate an adaptive smart control feature to actively track battery capacity and adjust light output accordingly. Prior to including this feature, selecting a light output percentage on the remote determined the constant percentage of max LED brightness. Now with (IAP), the controller actively monitors the battery and regulates the electrical current to the LEDs. The controller now applies the selected percentage output on the remote to the battery capacity, rather than the max LED output. This smart-control feature can increase our off-grid performance by up to 40%.
   Important
   Dust and dawn time may be diffrent in other locations and seasons. The sensors of our products will follow the light patterns of where it is installed. The time period shown in the chart above is just an example to help you understand the different lighting modes only.

7. 100% Constant Mode
   100% brightness from dusk to dawn.

8. 70% Constant Mode
   70% brightness from dusk to dawn.

9. 40% Constant Mode
   40% brightness from dusk to dawn.

10. Timer Mode Disabled
    Press this button to turn off Timer Mode; settings revert back to before Timer Mode was last activated.

11. Timer Mode 4 Hours
    This is an additional mode which can work with any other modes. For example: press this button at any time after you turn on 70%Constant Mode. If the light turns on at 7pm at dusk, it will turn off at 11pm. It will repeat the same schedule hereafter until it is canceled by pressing Timer Mode Disabled .

12. Time Mode 8 Hours
    This is an additional mode which can work with any other modes. For example: press this button at any time after you turn on 70% Con-stant Mode. If the light turns on at 7pm at dusk, it will turn off at 3am. It will repeat the same schedule hereafter until it is canceled by pressing Timer Mode Disabled .

Important
Dust and dawn time can vary for different locations and seasons. The sensors in our products will monitor the light levels where it is installed. The time period shown in the chart above is just an example to help you understand the different lighting modes.
CEGONIA products are covered by a 5 year limited warranty. CEGONIA urban light warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 5 years from date of purchase. To obtain warranty service please contact your local distributor or sales rep for further instruction.

1460 Park Avenue.
Emeryville, CA 94608 USA
www.soltechlighting.com
SOLTECH LLC reserves the right to update all product data sheets at any time. Consult SOLTECH marketing specialists for publication updates at hello@soltechlighting.com
Copyright©2021–2022 SOLTECH LLC,
All Rights Reserved.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>