SOLTECH TEMPO Mobile Solar Light Tower Installation Guide
- June 6, 2024
- SOLTECH
Table of Contents
SOLTECH TEMPO Mobile Solar Light Tower
Introduction
Outdoor solar lighting systems use solar cells which convert sunlight into
electricity. Electricity is stored in batteries for use at night. TEMPO Mobile
Solar Light Tower combined with SUNLIKE solar lights are easy to install and
virtually maintenance-free. Using them avoids trenching, cabling, and
electricity costs.
Important
In order to avoid deep discharge of the battery during storage, please fully
recharge your battery every 4 months. Please make sure that the light is
installed in an area with sufficient sunlight. A strict minimum of 3.5
hours/day of sunshine on average is recommended. Select the right operating
mode according to local codes and solar conditions. Keep it away from shadows.
Self-cleaning occurs when the light fixture has a minimum angle of 15 degrees
above horizontal. Please save these instructions. Read all of the instructions
carefully before attempting to carry out any installation or wiring. Do not
open or attempt to repair an SOL TECH luminaire on your own, as it may cause
serious damage and would void the product warranty. Contact your local
distributor for any questions concerning the installation. The range of the
lighting fixtures is 20–26 feet (6–8 meters). The ideal installation spacing
between fixtures is <16 feet (5 meters). When installing two or more light
fixtures on one pole, select desired operating mode before installation.
Radiofrequency interference can cause delay or malfunction of the remote
control when changing operating modes, after installation.
Precautions when working with solar panels
When the solar panel is exposed to sunlight, a voltage appears at the output
terminals of the solar panel, turning it into a source of electricity. To
avoid a shock hazard, make sure the solar panel is covered with an opaque
(dark) covering, such as paper or cloth, during the installation. Do not make
contact with the terminals when the panel is exposed to sunlight or any other
light source.
Specifications
| Specifications | TEMPO |
|---|---|
| Max Height | 14.3 ft (Without Luminaire) |
| Collapsed Height | 7.5 ft (Without Luminaire) |
| Mast Material | Steel |
| Mast Profile | Square |
| Mast Sections | 3 |
| Operation | Manual Winch 1500 Lbs |
| Mast Max Load | 110 Lbs |
| Max Wind Speed | 90 mph |
| Warning Strips | Included |
| Lift Limit Stopper | Included |
| Lifting Eyes | X4 |
| Fork Pockets | Included |
| Wheel | N/A |
| Mast Flange | Removable |
| Weight | 770 Lbs (Without Sand Ballasting and Luminaire) |
| Dimensions | 40.0 inches X 40.0 inches X 90.0 inches (Collapsed Without |
Luminaire)
Luminaire Specifications| SUNLIKE 20W| SUNLIKE 30W| SUNLIKE
PRO 30W
---|---|---|---
LED Nominal Power| 20W| 30W| 30W
Solar Panel| 18V 36W| 18V 52W| 18V 52W
Battery| 256WH 12.8V 20AH LiFePO4| 384WH 12.8V 30AH LiFePO4| 320 WH
12.8V 25AH Superior
Weight| 21.4 lbs| 29.8 lbs| 47.1 lbs
Lumen Output@5000K| 4,000| 6,000| 6,000
CRI| > 70| > 70| > 70
LED Chip| Lumileds 5050 (215lm-CR>70)| Lumileds 5050 (215lm-CR>70)|
Lumileds 5050 (215lm-CR>70)
EPA| 4.75| 6.26| 6.26
Waterproof Rate| IP65| IP65| IP65
Casting| Aluminum| Aluminum| Aluminum
Efficiency@5000K| 200 lm/W| 200 lm/W| 200 lm/W
*** Charging Time| 7hrs| 7hrs| 7hrs
Run Time(@Full Power)| 10hrs| 10hrs| 11hrs
Operation Mode**| Remote control and
One-key Setting
| Remote control and
One-key Setting
| Remote control and
One-key Setting
Installation Height| 9 to 16ft| 9 to 20ft| 9 to 20ft
Operating Temperature| -4 °F to 122 °F| -4 °F to 122 °F| -4 °F to
140 °F
Charging Temperature| 32 °F to 149 °F| 32 °F to 149 °F| -58 °F to
140 °F
Maximum Autonomy
Motion Sensor Mode
| ****
40%–100% 35hrs
20%–80% 55hrs
| ****
40%–100% 35hrs
20%–80% 55hrs
| ****
40%–100% 25hrs
20%–80% 50hrs
Time Control Mode
| ****
Night Owl 28hrs
Early Bird 25hrs
| ****
Night Owl 28hrs
Early Bird 25hrs
| ****
Night Owl 23hrs
Early Bird 20hrs
Constant Mode
| 100% 11hrs
70% 15.5hrs
40% 27hrs
| 100% 11hrs
70% 15.5hrs
40% 27hrs
| 100% 11hrs
70% 15hrs
40% 26hrs
Installation and Wiring Requirements
- Installation and wiring must comply with the State and National Electrical Codes.
- The SUNLIKE 20W/30W/30W PRO models are intended for outdoor use only and should not be installed in an unventilated area, and must be installed in an environment within the operating temperatures defined for the product.
- The average sunshine in the installation area should be above 3.5 hours/day in order to ensure the full functionality of the light fixture. Avoid areas with shade.
- Before installation, if applicable, please ensure the light pole and its foundation are stable enough to withstand the lighting fixture(s).
- Before installation, please ensure that the battery is fully charged. Install during sunny days if possible.
- Before installation, press the ON/OFF key on the remote control and check whether it shows a red light on the indicator. Cover the solar panel and check if the light module turns on normally within 1 minute.
After Installation: The light fixture will automatically turn on at night
and turn off during daylight.
Important: Always orient the solar panel facing the equator (e.g. facing
south if in the northern hemisphere). Always have a tilt angle of at least 15°
to avoid dust accumulation (0°=horizontal plane).
Ordering Information
| Tower | Fixture |
|---|
STLTWR02M =TEMPO Solar
| Series| Wattage| Optic Type| Color Temperature|
Mounting Options| Finish
| | | | |
Mobile Tower|
STLSTC =SUNLIKE
|
20 =20W
|
T2 =TYPE II
|
3 =3000K
|
SF =Slip Fitter
|
GY =Gray
| STLSTCPRO
=SUNLIKE PRO
| 4000 Lumens
(only for SUNLIKE)
30 =30W
| (only for SUNLIKE 30W SUNLIKE PRO 30W)
T3 =TYPE III
| 4 =4000K
5 =5000K
| |
| | 6000 Lumens| T4 =TYPE IV| 6 =5700K| |
| | | (only for SUNLIKE 30W| | |
| | | SUNLIKE PRO 30W)| | |
For example: STLTWR02MSTLSTC020T33SFGY
This means the customer wants a Solar Mobile Tower Tempo, SUNLIKE 20W, TYPE
III, 3000K CCT, Slip Fitter installation, with a Gray finish.
DO NOT send the sample number directly to our salesperson. Use the
information in the chart above to create a model number with
the correct series, wattage, temperature, mounting option, and finish for the
product that you want.
Installation
-
Install The Pole
-
Sand Ballasting
-
Install Tenon and Luminaire
-
Adjust The Pole Height
Panel Angle
The Solar charge in a battery pack won’t last forever. The off-grid system
relies on stored solar energy for autonomy. Angling your solar panels properly
can boost the power intake of your solar lighting system. You want to angle
your solar panels at a tilt based on the area’s latitude.
Tip: You can increase the tilt by 15° in the winter or decrease it by 15°
in the summer. In this way, you can get the maximum sunlight to recharge the
battery bank.
The area will dictate the installation of the fixtures and will sometimes prevent the lights from facing south. But that’s okay! Panels facing West & East won’t get as much light as Southern facing panels, but will still collect a good amount of sunlight. A North facing panel also works, but it will take longer to charge than any other direction. This would mean that the solar charge will be less optimal if installations are facing North.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>