TOVEENEN BG10B-RT Color Changing LED Landscape Light User Guide
- June 6, 2024
- TOVEENEN
Table of Contents
BG10B-RT Color Changing LED Landscape Light
Color Changing LED Landscape Light Outdoor Tree Garden Holiday Décor Lighting
USER GUIDE
Contact Customer Service: support@toveenen.com
Manufacturer: Shenzhen SYG Technologies Co., Ltd.
Address: Room 402, Dunbeixincun 2-46, Shenzhen, China
- Make sure this light is connected to the circuit with a Ground Fault Circuit Interrupter (GFCI) and a circuit breaker.
- Keep the button cell out of the reach of children.
- This light cannot be submerged in water for a long time.
INSTALLATION
- Unscrew the screw on the stake with allen wrench.
- Install the stake on the bracket of light with the screw.
- Tighten the screw with allen wrench.
- Push the stake into ground or mount the light on the wall with metal base.
- Adjust the lighting direction as needed.
FEATURES & SPECIFICATION
- Color modes: 16 colors and 4 color-changing modes.
- RF Remote Control: RF Remote can work through wall, window or door.
- Color Memory: It will remember the last color when power is off.
- Metal lamp body and stake, Cooling Fin, IP65 waterproof design.
Input Voltage
|
85~265 VAC
|
Wattage
|
10 Watt
---|---|---|---
Beam Angle
|
90°
|
Waterproof
|
IP65
Material
|
Aluminum
|
Weight
|
1 lb
Remote Type
|
RF
|
Battery Type
|
CR2025
REMOTE CONTROLLER
RF remote can work through obstacles, without pointing at lights. Please take out the plastic sheet in the battery compartment before use.
BUTTONS
∧ ∨ Increase or decrease brightness
ON / OFF: Turn on or turn off the light.
16 colors:
R: Red G: Green B: Blue
W: White (R+G+B)
Other 12 colors
4 color-changing modes:
FLASH, STROBE, FADE, SMOOTH
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>