Conido BER-ST14-Black Smart Watch Charging Station User Guide
- June 6, 2024
- Conido
Table of Contents
Conido BER-ST14-Black Smart Watch Charging Station User Guide
Part List Note:
If ports in the packing box don’t check with the list, please contact us in time.
Charging Stand *1
USB Cable *1
ADJUSTTHE HEIGHT TOADAPTERIWATCH SERIES
NOTE!!!
-
Please align your apple watch to the charging center, the charging stand for app.a watch has on acfus table base, you
can rotate back’s knob. -
Rotate the knob on the back to get an appropriate height for your Apple Watch series 5, 4 ,3 ,2, 1 to align the charging center, if not charging, please check this step, find appropriate place to align the
charging center .
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Any
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.