GemRed 82428 Rova Por Device Instructions

GemRed 82428 Rova Por Device Instructions

ON/OFF

With the unit off, press the ON/OFF button to turn the unit on. With the unit on, the light flashed,hold the ON/OFF button for 3 seconds to turn on.

Use Instruction

1. Get ready: Open the upper case of the unit, put in ER14250 battery, and close back the upper case
2. Connect the unit with the app on Smart phone
3. Complete the setting on the app, then start to use.
4. RV Leveling: after parking, connect the unit with app and level your RV with the direction on the app.
5. Installation: Setting the orientation of the installation on the app, and use screws fixed the unit. Click “Set level” to complete the installation.
6. The app dis[lays height required to reach a level position.

Technical parameters

App Download

Scan the QR code to download the app

The mobile phone is very likely to pop up a security prompt for security risk protection, and you could ignore the prompt and download the app.

Bluetooth Connection

1. Press ON/OFF, turn on the unit; Turn on blueooth of the phone and open the app.

2. Click “Bluetooth Connect” on the app and choose the bluetooth name of th’s

APP User Manual

First use

After connected the unit, please follow the instruction to complete the setting.

Measurement Interface

1. Save/Recall position For tow vehicle, you could save and recall your hitch position
2. App display Temperature Bluetooth Signal Strength Bluetooth Connection Status The battery level of the unit
3. Settings You can change your setting and re setup level
4. View Switch You can switch the top view or front view
5. Leveling instruction displays heights required to reach a level position

Setting

1. Length unit cm/inch
2. Resolution Display Height resolution
3. Language Chinese/English
4. Vehicle Type tow vehicle/motorhome grams
5. Wheels’ distance the width or the length between wheels MIS
6. Installation Orientation please make sure the installation orientation is the same your choice
7. BluetoothSearch for the units
8. Setup level; setup the unit to compensate for the deviation

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>