GemRed PetGrow Smart Tape for Pet Instructions
- June 9, 2024
- GemRed
Table of Contents
PetGrow-Smart Tape for Pet User Instruction
Display
| Low battery warning
---|---
| Bluetooth connection
cm/in| Measuring unit
| Measuring data
Charging Light
When the LED shows red light, it means the device is charging. After fully charged, the light turns off.
How to Use
- Download the “Petros” APP, then register an account on the APP.
- Enable the Bluetooth, and open the APP.
- Turn on the Tape, and it will be connected to the APP automatically.
- Select any “body part” on the App and then pull out the tape buckle to measure your pet.
- Short press the tape retractable button, make sure the tape is as closely as possible to your pet’s body part.
- Short press the “M” button, the measuring data will be transmitted to the APP on your phone.
- Click “Save” on the APP to keep the data after measurement.
Note: the Display will be dimmed if there is no any operation within 10 seconds, and turned off within 1 minute.
Technical Data
Accuracy | 2%o | Measuring Range | 1500mm/60in |
---|---|---|---|
Resolution | cm/in | Battery | 150mAh |
Measuring Unit | 0.1cm/0.04in | Charging Port | TYPE-C |
Working Temperature | 0°C-40°C | Working Humidity | 85% |
Download the APP
- For Android system, please search the key word “Pet Grow” on Google Play.
- For loss system, please search the key word “Pet Grow” on APP Store.
Bluetooth Connection
- Turn on the device by short pressing the power button.
- Turn on the Bluetooth on your phone and open the App.
- The Bluetooth icon will be bright after the connection successfully.
Trouble Shooting
Problem | Possible Cause | Solution |
---|---|---|
After click the retractable button, it does not reset “zero” on the Display. | ||
The retraction acts too fast. | Long press the power button and the “M” button |
at the same time to reset it to “zero”.
No data shows on the Display when pull out the tape.| System halted.| Reset
the device. (Long press the power button for 13 seconds.)
- The product contains small accessories. Keep the product out of the reach of children t o prevent swallowing.
- Specified type of battery is required. The voltage of external power supply should meet the requirements, if not installed and used in accordance with the instructions, may cause damage or fire.
- Do not disassemble, repair, or modify the device, otherwise, may cause damage to the product.
Caution: The user is cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority t o operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation i s subject t o
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found t o comply with the limits for
a Class B digital device, pursuant t o Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference t o radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged t o try t o correct the interference by one or more of the
following measures:
- Reorient o r relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that t o which the receiver i s connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. ‘
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>