MAXIM MUT08 8L Stainless Steel Urn User Manual

MUT08 8L Stainless Steel Urn User Manual

READ AND SAVE THESE INSTRUCTIONS

Read and follow the instructions in this user manual even if you feel you are familiar with the product, and find a place to keep it handy for future reference.
For your convenience record the complete model number (located on the product identification plate) and the date you received the product, together with your purchase receipt, and attach it to the warranty and service information. Retain in the event that warranty service is required.
NOTE: The rating of this product (as marked on the product identification plate) is based on specific loading tests. Normal use or the use of other recommended attachments may draw significantly less power.

IMPORTANT SAFEGUARDS

When using any electrically powered product, basic safety precautions should always be followed, including the following:
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT
WARNING: To reduce the risk of burns, electric shock, fire, injury to persons or property:

• Carefully read all instructions before operating your new product for the first time and save for future reference.
• Remove and safely discard any packaging material and promotional labels before using the Urn for the first time.
• To eliminate a choking hazard for young children, remove and safely discard the protective cover fitted to the plug of this appliance.
• This urn is designed specifically for the purpose of boiling drinking quality water only. Under no circumstances should this urn be used to boil any other liquids or foodstuffs.
• Do not place the Urn near the edge of a bench or table during operation. Ensure the power cord does not hang over the edge of the bench or table, touch hot surfaces or become knotted.
• Do not place the Urn on or near a hot gas or electric burner, or where it could touch a heated oven. Do not use the Urn on a sink or drainboard.
• Ensure the Urn is placed at least 20cm from walls, curtains, and other heat-sensitive and flammable materials. Always operate the Urn on a flat, even, dry, heat-resistant surface.
• This Urn is not intended to be operated by means of an external timer or separate remote control system.
• During operation, the outer surface will become hot, avoid touching the metal parts.
• Ensure the urn is always properly assembled before use.
• Do not attempt to move the urn while it is full or in use.
• Do not place anything on top of the lid.
• Do not open the lid during operation.
• Use caution when using the urn, as boiling water and steam will scald. Avoid pouring the water too quickly.
• Steam may escape from the top of the urn; care should be taken at all times.
• Do not fill the Urn past the MAX water fill line.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure they do not play with the appliance.
• This appliance is for household use only. Do not use this appliance for anything other than its intended use. Do not use in moving vehicles or boats. Do not use outdoors. Misuse may cause injury.
• The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice.
• This appliance contains no user-serviceable parts. Any maintenance other than cleaning should be performed by a qualified person.
• Do not immerse the unit, power plug, or power cord in water, or any other liquid.
• Never operate any appliance with a damaged power cord or plug, should the appliance malfunction, or if it has been damaged in any manner.
• Do not leave the appliance unattended whilst it is on.
• Before cleaning, always turn the appliance off, switch it off at the power outlet, and unplug at the power outlet. Allow the appliance to cool completely before undertaking any cleaning.
• Do not allow cold water to sit in the urn for more than 2 days, as it could stagnate, which is very unhygienic. Empty the water out and refill the urn if water has been sitting in the urn for more than 2 days.

DO NOT POSITION THE URN SO THAT THE TAP HANGS OVER THE COUNTER EDGE. IT IS NOT DESIGNED TO BE USED THIS WAY AND COULD LEAD TO SERIOUS SCALDS SHOULD THE TAP BE SWITCHED ON BY MISTAKE.

POWER SUPPLY

• If the unit uses a mains power supply, ensure that the plug is securely inserted into the mains socket and it is easily accessible.
• Protect the power lead from sharp objects, excessive heat, and damp or wet locations.
• Check the power lead periodically, and replace it if damaged.
• Check that the voltage on the rating plate of your product corresponds with your local electricity supply which must be A.C. (Alternating Current).
• Any repairs should only be carried out by a fully qualified electrician or an authorized service agent.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.

ELECTRIC CIRCUIT DIAGRAM

FEATURES

A. Cool touch handles

B. Lid| F. Heating indicator light
C. max fill line| G. Thermostat
D. Water gauge| H. ON/OFF switch
E. Tap| I. Keep warm indicator light

BEFORE FIRST USE

• Carefully remove your Urn from the box and remove any packaging materials.
• Fully unwind the power cord.
• Fill to ‘Max’ fill line, boil, discard the water and then rinse. Repeat this three times, to remove any dust, residues, etc, from the Urn.

INSTRUCTIONS

1. Remove the lid and fill the urn with the desired amount of water taking care not to fill past the MAX fill line. Avoid underfilling the urn as this will cause the overheat protection system to operate and could reduce the life of the element.
2. Replace the lid and ensure that it locks into place.
3. Connect the urn to a suitable 220-240Vac ~ 50Hz mains supply.
4. Press the “ON” switch and the red “Heating” indicator light will light up while it begins to boil. When the water reaches the boiling temperature, the “Keep Warm” indicator will light up and the water in the urn will maintain the boiling temperature in the “Keep Warm” mode.
5. The time taken to reach the boiling temperature will be depended on the volume of water in the urn and the temperature of the water when the appliance was switched on.
6. To pour hot water, place a cup below the non-drip tap and push the tap down. For continuous pouring, lift the tap up until it is in a vertical position.
7. After use and before cleaning switch the appliance ‘Off’, turn the power supply off, and unplug the appliance from the electric outlet.
8. The unit will stop heating and start to keep warm when the water has reached the pre-set temperature.
   For example, if you set the thermostat to 100 degrees once the water has been heated up to this temperature the heating will switch off and turn to the warm function.

NOTE: In all cases, it will be necessary to regularly check the water level each time before use, to ensure that this appliance does not burn out. We recommend you refill the urn if there are less than three cups of water inside.

NOTE: The urn is not designed to constantly boil water. This would fill the room with steam. It is designed to heat water and maintain a temperature that is ideal for hot beverages such as tea or coffee.

NOTE: Do not open the lid when the urn is in operation as steam may escape from the top of the urn.
TIP: When filling cups etc with hot water, hold them as close to the tap as possible to avoid hot splashes.
SAFETY CUT OUT: The Urn features a boil dry protection system, which will switch off the element if the water level is too low. To reset the safety cut out, switch off and unplug the urn and allow it to cool. Refill with cold water and switch the urn back on again.

CARE & CLEANING

ALWAYS LET THE URN AND WATER COOL BEFORE CLEANING.
Always unplug the appliance before you clean it. The outside of the urn can be cleaned with a moist cloth and a small amount of detergent. If you need to use a detergent solution for the inside of the urn please rinse thoroughly before use. Never use scouring pads, abrasive cleaning agents, or aggressive liquids such as bleach to clean the appliance. Never immerse the Urn or its base in water. Dry the urn with a kitchen towel or similar after cleaning.

DESCALING
Excessive limescale build-up can cause the element to overheat and can even cause the tap to malfunction! Make regular checks of the inside of the urn for signs of limescale. It is essential that limescale deposits be cleaned using proprietary Descaling tablets, powders, or liquids (available from most supermarkets). Those in hard water areas may need to descale the urn every week. Those in soft water areas won’t need to descale the urn quite as often.

For a heavily scaled urn use approximately FOUR TIMES the amount of Descaling product required for an urn.
Repeat if necessary.

SPECIFICATIONS

CUSTOMER SERVICE

Australian Customer Service
GAF Control (Sales) Pty Ltd
P.O Box 19
Altona North Victoria 3025
Phone: 1300 659 489
Hours: 9am-5pm (EST) Mon-Fri
www.gafcontrol.com.au

*This product may vary slightly from the product illustrated due to ongoing product development.

WARRANTY
Our goods come with guarantees that cannot be excluded under Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The above applies subject to the item not being accidentally dropped by the user- or being used for purposes other than the intended use – or being tampered with. GAF Control (Sales) Pty Ltd guarantees the product for 12 months from the date of purchase. Refunds or replacements at the retail store level are under the guidance of the store’s rules/regulations. In the event of requiring assistance, the retailer from whom you purchased the product should be your first port of call.

Supplier warranting this product:
GAF Control (Sales) Pty Ltd
P.O. Box 19, Altona North
Victoria, 3025, Australia. 

12 months warranty from date of purchase. 90 days warranty from date of purchase if used commercially. If your retailer has not validated your guarantee, then retain your purchase receipt. The guarantee does not cover accidental breakage or damage of your product or if it has been tampered with.

Product Model Number: MU08
Purchase Date: ____
Retailer: __
Retailer Store Address: __
Name of Purchaser: ____
Address: __

Due to the Maxim policy of continual product development; specifications, colours and details of our products as listed or depicted in this user manual or on the product and its carton may differ slightly

Product: Made in China.

To view the full range of Maxim Housewares products, please go to our website.
www.gafcontrol.com.au

For additional consumer support – email us at:
gaf@gafcontrol.com.au 

References

• Home | GAF Control
• Home | GAF Control

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>