Power Dynamics 182.240 Spider Deck 750 Instruction Manual
- June 6, 2024
- Power Dynamics
Table of Contents
Dynamics 182.240 Spider Deck 750
Instruction Manual
Make sure that you read and understand this manual completely before using
this system. This manual shall be available for everyone assembling,
disassembling, or loading the Power Dynamic Spider Deck750.
For health and safety reasons people assembling, disassembling, transporting,
and maintaining the stage deck should wear adequate Personal Protection
Equipment like gloves, hardheads, and safety shoes. Elements weighing 20 kg or
more shall be carried by at least 2 persons.
SCOPE
Spider Deck750 is a modular framework with different types of topping to be
used as a raised platform for purposes of displaying, performances, etc
LIMITATIONS OF USE
Due to its natural action, the plywood may shrink and expand depending on its
humidity and ambient temperature. It should be used at a humidity level
between 22% and 42% and a temperature between 18 and 26°C.
ASSEMBLY INSTRUCTIONS
Tools required:
- Allen key size 8
- Spirit level
NOTE: Please check all connections such as deck to deck clamp, leg to leg clamp, and the overall stability of the system before loading.
RISER ASSEMBLY
- Extend the Spider risers to about 80% of their maximum width.
- Place the stage deck upon the Spider risers.
- Completely extend the risers until they click into place.
- Check whether all the elements are fitted properly.
ATTENTION! Please make sure that the complete unit is stable and well assembled before using it.
DECK TO DECK CLAMP
- In order to connect two-stage decks, slightly pull them out of each other to create adequate space for inserting the Spider Stage clamp.
- Loosen the Allen screw to make the Spider Deck to Deck clamp more flexible.
- Slide the Spider Deck to Deck partially into the slot, to connect both stage decks.
- Once you have succeeded, insert the Spider Deck to Deck completely into the slot.
- Tighten the Allen screw.
- In this way, the stage decks are fitted to each other not only on the outside but also on the inside of the installation, which adds to the overall stability.
EXAMPLE STAGE 3X2M
CAUTION! The height difference between the stage decks should not exceed 2mm to avoid tripping.
MAINTENANCE
- Keep the system free of dust.
- Clean all parts with a damp cloth and warm water. Avoid cleaning materials and chemical liquids.
DO AND DON’T
Do!
- Check to ensure the stage floor is properly aligned and completely level.
- Check the application conditions of your stage, as the type of use is directly related to safety issues like handrails.
- Brace your staging legs when needed for stability.
- Make sure all stage elements are interconnected.
- Take notice of local regulations for stages and allowed purposes.
- Store stage deck upside down to decreases setup time.
- Maintain your stage deck at regular intervals.
- Make sure your construction is properly grounded.
Don’t!
- Use materials in poor condition, the payload might be reduced substantially.
- Apply loads before knowing their exact weight and size.
- Exceed the maximum allowable load.
- Use unfinished stage deck top board in outside conditions.
- Exceed the maximum building height of the stage or its support frame.
- Use the hang-on profile without reducing the maximum allowable payload.
- Build your stage on unstable ground.
- Use stage deck elements as ballast for your roof without using the proper support frame.