Lastar DL003W LED Floor Lamp User Manual

**Lastar DL003W LED Floor Lamp User Manual

**

Remote Control

1. Short press ON/OFF switch, the indicator light goes off is ON, and goes on is OFF
2. Short press and the indicator light flashes, you can set 60-minute timer. Short-pressing again, the indicator light goes off.
3. Short press and the color temperature increases, it’s followed by 3000K,4000k,5000k,6000k, 6000K is the highest color temperature.
4. Short press and the color temperature decreases gradually, it’s followed by 6000K,5000K,4000K,3000K,3000K is the highest color temperature.
5. Short press and the brightness level increases, it’s followed by 25%,50%,75%,100%.The fourth tranche is the brightest.
6. Short press and the brightness level decreases, it’s followed by 100%,75%,50%,25%. Level 25% would be a minimum brightness .

Product Diagram

1. Lamp Head
2. Gooseneck
3. Control Panel
4. Pole Section
5. Base
6. Power Connector

Assembly and Disassembly

Note:

• When connecting the sections, rotate in opposite directions with both hands and do not screw with too much force.
• You can choose to use different numbers of sections for different purposes and scenes. To disassemble, follow the assembly steps as above in the reverse order.

How To Use

Power On / Off

Tap the Power Button to turn the lamp on / off.

Color Temperature / Brightness Adjustment

Tap the Color Temperature Button to cycle through 4 color temperature settings. Tap the Brightness + / -Button to adjust 4 levels of brightness in each color temperature setting.

Auto Shutoff Timer

Press and hold the Power / Timer Button for 2 seconds, the Power Indicator will start to flicker and activate a 45 minutes auto shut-off timer. Repeat this operation or press the Power / Timer Button to turn off the timer.

Adjust the Lamp Head

Note: Please do not turn the lamp head for over 180° to avoid damaging the gooseneck.

Specifications

Caution

• Please do not dismantle the product by yourself, always ask a professional electrician or authorized technician for repairs.
• If you smell a bad odor or anything unusual, please turn off the unit immediately.
• Please do not remove the power cable with wet hands as it may cause an electric shock.
• Do not put this unit near extreme heat sources, moisture, or corrosive substances.
• Clean the lamp with a dry cloth when needed.
• Please store the lamp in a dry and shady place if not being used for a long period of time.
• Use the original power adapter to power the lamp. A wrong input may damage the lamp.

FCC Statement

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1 )this device may not cause harmful interference. (2)this device must accept any interference received, including interference that may cause undesired operation.

WEEE Compliance

Correct Disposal of This Product (Waste Electrical & Electronic Equipment)
(Applicable in countries with separate collection systems)

This marking on the product, accessories or literature indicates that the product and its electronic accessories should not be disposed of with other household waste at the end of their working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate these items from other types of waste and recycle them responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take these items for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product and its electronic accessories should not be mixed with other commercial wastes for disposal.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>