Lastar CM006R LED Floor Lamp User Manual
- June 15, 2024
- Lastar
Table of Contents
LED FLOOR LAMP
User Manual
Remote Control
- Short press ON/OFF switch, the indicator light goes off is ON, and goes on is OFF.
- Short press and the indicator light flashes, you can set 60-minute timer. Short-pressing again, the indicator light goes off.
- Short press and the color temperature increases, it’s followed by 3000K,4000k,5000k,6000k, 6000K is the highest color temperature.
- Short press and the color temperature decreases gradually, it’s followed by 6000K,5000K,4000K,3000K,3000K is the highest color temperature.
- Short press and the brightness level increases, it’s followed by 25%,50%,75%,100%.The fourth tranche is the brightest.
- Short press and the brightness level decreases, it’s followed by 100%,75%,50%,25%. Level 25% would be a minimum brightness.
• Within 5 seconds of powering the floor lamp up, press the brightness+/brightness- buttons of remote control simultaneously, the main light will flash once indicating that successful code pairing.
Product Diagram
Product Diagram
1. Lamp Head
2. Gooseneck
3. Control Panel| 4. Pole Section
5. Base
6. Power Connector
---|---
Assembly and Disassembly
Note:
- When connecting the sections, rotate in opposite directions with both hands and do not screw with too much force.
- You can choose to use different numbers of sections for different purposes and scenes.
To disassemble, follow the assembly steps as above in the reverse order.
How to Use
Power On / Off
- Tap the Power Button to turn the lamp on / off.
Color Temperature / Brightness Adjustment
Tap the Color Temperature Button to cycle through 4 color temperature
settings. Tap the Brightness + /- Button to adjust 4 levels of brightness in
each color temperature setting.
Auto Shutoff Timer
Press and hold the Power / Timer Button for 2 seconds, the Power Indicator
will start to flicker and activate a 60 minutes auto shut-off timer. Repeat
this operation or press the Power / Timer Button to turn off the timer.
Adjust the Lamp Head
Note: Please do not turn the lamp head for over 180° to avoid damaging the
gooseneck.
Specifications
| Model | CM006R |
|---|---|
| Light Source | LED |
| Operate Voltage | 10V 1.2A |
| Power | IOW |
| Color Temperature | 3000K-6000K |
Caution
- Please do not dismantle the product by yourself, always ask a professional electrician or authorized technician for repairs.
- If you smell a bad odor or anything unusual, please turn off the unit immediately.
- Please do not remove the power cable with wet hands as it may cause an electric shock.
- Do not put this unit near extreme heat sources, moisture, or corrosive substances.
- Clean the lamp with a dry cloth when needed.
- Please store the lamp in a dry and shady place if not being used for a long period of time.
- Use the original power adapter to power the lamp. A wrong input may damage the lamp.
Manufacturer: Shenzhen Chuanming Technology Co., Ltd
Address: Room 908, Block A, Zhongguan Times Square ,
No.4168 Liuxian Avenue, Nanshan District, Shenzhen, China 518000
E-mail: service@lastarhome.com
CM006R_V1.0
MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>