Shenzhen Omni Intelligent Technology G3 IoT Device User Manual
- June 6, 2024
- Shenzhen Omni Intelligent Technology
Table of Contents
Shenzhen Omni Intelligent Technology G3 IoT Device
Product Name: IOT device
Product Model: G3-KS-OM-NA-P
Product introduction
This is a sharing scooter iot controller, through 4G GPS, BLE5.2 Bluetooth and smart phone APP for data communication to control the startup/shutdown of the scooter, the cloud server automatically counts the time and deducts the fee.
Product working for frequency band
NO. | Item | Frequency Band | Max launch Power |
---|
1
|
network
|
3G: WCDMA
| B2| 0.2W
B5| 0.398W
2
|
network
|
4G: FDD-LTE
| B2| 0.2W
B4| 0.251W
B12| 0.251W
3| Bluetooth| 2402-2480MHz| -13 dBm
4| GPS| 1561.098MHz, 1575.42MHz
1602.5625MHz
| Only receive, not transmit
APP installation and registration:
- For APP download, please go to the official website of corresponding to the mobile phone operating system to download and install it.
- User account registration and login. This step requires the mobile phone to be connected to the Internet, and the user account is a normal mobile phone number
- Deposit recharge, car fare recharge .
On/off operation instructions:
- Turn on Bluetooth in the mobile phone system.
- Open the APP, click the QR code button in the middle below the APP, enter the scan QR code page, and scan the QR code with the iot controller. When the mobile phone scans and reads the QR code information, the lock will automatically open and enter the state of using the car.
- When the car is used up, click close the lock, the cloud service will automatically stop the time counting and deduct the charge after receiving the lock.
The IoT controller needs to be used with a smartphone, and the mobile phone
hardware environment requires:
Android 4.3 or above, hardware support Bluetooth 4.0BLE, the best screen
resolution is 1280×720; IOS 7.1 or above, iphone 4s or above.
APP page introduction
home page
Scan the QR code page
Unlock and use the car page
Successful deduction page
CAUTION
Risk of explosion if the battery is replaced by an incorrect type; disposal
of a battery into fire or a hot oven, or mechanically crushing or cutting of a
battery, that can result in an explosion; leaving a battery in an extremely
high temperature surrounding environment that can result in an explosion or
the leakage of flammable liquid or gas; a battery subjected to extremely low
air pressure that may result in an explosion or the leakage of flammable
liquid or gas
Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>