MERCUSYS ME30 Range Extender Installation Guide
- June 6, 2024
- MERCUSYS
Table of Contents
MERCUSYS ME30 Range Extender
For technical support, the user guide and more information, please visit http://www.mercusys.com/en/support
-
Power on
Plug the extender into a power outlet near your router, and the Signal LED turns solid red. -
Connect to the extender
Connect your wireless device to the extender’s network MERCUSYS_RE_XXXX.
Note: The default SSID (network name) is printed on the product label at the back of the extender. -
Configure
-
Launch a web browser and enter http://mwlogin.net
Create a password for future login attempts. -
Select your router’s host network and enter the network password when prompted.
-
Check the Signal LED on your extender. Green or orange LED indicates a successful connection.
-
-
Relocate
To achieve better signal quality, plug in the extender halfway between your router and the Wi-Fi dead zone.
Image may differ from actual product.
Enjoy!
Connect your device to the extender using the extended SSID. The default Wi-Fi
password is the same as your host network.
LED Explanation
(For Range Extender Mode)
Off Power is off.
Blinking The extender is starting or connecting to the host network.
Solid Red The extender is not connected to the host network.
Solid Green The extender is connected to the host network band works
well.
Solid Orange The extender is connected to the host network, but is too
far away from the router.
FAQ (Frequently Asked Questions)
Q1 How do I configure the extender using WPS?
- Plug the extender into a power outlet near your router, and wait until the Signal LED is lit and solid red.
- Press the WPS button on your router.
- Within 2 minutes, press the WPS or RESET/WPS button on the extender. The LED should change from blinking to a solid state, indicating a successful WPS connection.
Q2 How do I reset the extender?
With the extender powered on, press and hold the Reset or RESET/WPS button
until the Signal LED turns off, then release the button. When the Signal LED
turns solid on, the
reset process is complete.
Q3 What should I do if I cannot access the extender’s web management page?
- Make sure your wireless device is connected to the extended network using the extended SSID.
- Verify that http://mwlogin.net is correctly entered in the web browser.
- If you are using a computer, make sure it is set to obtain an
IP address automatically.
Refer to Q2 to reset the extender and try again.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>