ITC elio 21055 VersiControl RGB Control Pad Instruction Manual
- June 6, 2024
- ITC elio
Table of Contents
ITC elio 21055 VersiControl RGB Control Pad
Install Instructions
-
PARTS / TOOLS NEEDED:
-
VersiControl RGB Smart Pad
-
RGB Lighting (Varies)
-
Mounting Screws x 22” Hole Saw Bit
-
Power Drill
Safety Instructions
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Do not install any luminaire assembly closer than 6” from any combustible materials.
- Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current.
-
INSTALL CONTROL PAD:
Determine the installation location of your control pad. Note the control module comes with a 7” long cord so the control pad will need to be located near the module. Drill a 2” hole and insert the control pad. Install the mounting bracket using the two 3x19mm stainless steel Phillips pan head screws provided. Do not fully torque screws until both have been partially installed.
-
CONNECT CONTROL PAD:
Insert the connector on the control pad into the connector on the module.
Controller
- V(+) – Brown
- V(-) – Gray
- Shield – Black
- Signal Line – White
- CAN (+) – Yellow
- CAN (-) – Green
*Mating connector Deutsch DTM06-6S
For warranty information please visit www.itc-us.com
- 3030 Corporate Grove Dr.
- Hudsonville
- MI 49426
- Phone: 616-396-1355 • www.itc-us.com sales@itc-us.com
- DOC#: 710-00026 Rev D06/01/21
OPERATION:
Below is the keypad overview, for more detailed operational instructions,
review your owners manual or visit http://www.itc-marine.com/product-
category/lighting/versicolor-rgb/
Note:
To reset the Bluetooth passcode and clear lock zones, press and release both
arrow keys at the same time.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>