SONY Visilion VT-G100 Device Instruction Manual
- June 6, 2024
- Sony
Table of Contents
Legal information
Vision VT-G100
Instructions for safe and efficient use
These instructions are for your own safety and to prevent device malfunction.
Failure to follow these may void your warranty and risk injury or harm.
Safe use and taking care of your device
-
Do not use a damaged device. It may cause injury or harm. If your device is damaged or you aren’t sure if it is working properly, contact your provider to have it checked and repaired.
-
Use Sony original accessories and spare parts. Non-Sony batteries, chargers, and spare parts may pose increased safety risks, such as fire, explosion, leakage, or chemical burns. Sony’s warranty does not cover failures or damage caused by non-Sony batteries, chargers, or spare parts.
-
Do not expose the device to excessive pressure or impact. Doing so may damage your device.
-
Use your device within its IP rating. Conditions, where IP rating limits might be exceeded, include environments with excessive humidity, water depths, liquid pressure, and dust exposure.
-
Treat the device with care and do not expose it to extremely high or low temperatures. Do not expose your device to temperatures below -30°C (-22°F) or above +60°C (+140°F).
-
Do not expose your device to flames or lit tobacco products.
-
Do not attempt to disassemble or modify your device. This device is equipped with an eSIM: do not attempt to modify it.
-
Do not cover the device with your hand as this affects quality and power levels and can shorten communication and standby times.
-
This device contains magnets and radio transmitters, which may interfere with pacemakers, defibrillators, programmable shunt valves, or other medical devices or equipment. Do not place this device close to such medical devices or persons who use such medical devices (minimum 15 cm (6 inches) between your device and the medical device). Consult your doctor before using this device if you use any such medical device. Turn off your device if you suspect interference.
-
This device and charger may contain small parts that could create a choking hazard or intestinal injuries. Keep this device away from children or other supervised individuals. If you know or suspect that you or anyone has swallowed a small part, seek medical attention immediately.
Potentially explosive atmospheres -
It is rare, but your electronic device could generate sparks or interfere with RF-controlled devices, which in potentially explosive areas could cause an explosion or fire resulting in injury or death. Turn off your device when in any area with a potentially explosive atmosphere, in a blasting area, or in areas where the warning “Turn off two-way radio” or other hazard warnings are posted.
Charging & Battery -
Unplug the charger before cleaning it to reduce the risk of electric shock.
-
Do not charge the device outdoors or near inflammable material as the heat can cause a fire.
-
Battery performance depends on temperatures, signal strength, usage patterns, features selected, and data transmissions. Using the battery in low temperatures may reduce its capacity.
-
Fully charge the battery before first use.
About RF exposure and Specific Absorption Rates (SAR)
Your device emits low levels of Radio Frequency (RF) energy when it is powered
on and when Bluetooth® functionality is enabled. RF energy exposure from
devices is quantified by a unit of measurement called the Specific Absorption
Rate (SAR). The SAR values for this device meet the international SAR limit
guidelines and are below the limits specified in those requirements. SAR data
information is provided for residents in countries that have adopted the SAR
limits recommended by the International Commission of Non-Ionizing Radiation
Protection (ICNIRP) or the Institute of Electrical and Electronics Engineers
(IEEE). The ICNIRP specifies Limb SAR limit of 4 W/kg averaged over ten (10)
grams of body tissue while the IEEE specifies Extremity SAR limit of 4 W/kg
averaged over ten (10) grams of body tissue. These requirements are based on
scientific guidelines that include safety margins designed to ensure the
safety of all persons, regardless of age and health. Tests for SAR levels are
conducted using standardized methods with the device transmitting at its
highest certified power level in all used frequency bands in head and body
positions. However, since the device is designed to use the minimum power
necessary to access a network, the actual SAR level can be well below this
value. While there may be differences between the SAR levels of various device
models, they are all designed to meet the relevant guidelines for exposure to
radio waves. The SAR values and test distances differ depending on the
measuring method, the device tested, but only the highest SAR values are
presented. The WHO (World Health Organization) has stated that current
scientific information does not indicate the need for special precautions
regarding the use of tablets and phones. For more information on this topic,
please visit who. int/emf and refer to Fact sheet No.193 who. int/media
center/factsheets/fs193 Electromagnetic fields and public health: mobile
phones. Additional SAR-related information can also be found on the Mobile
Manufacturers Forum EMF website at emfexplained.info. For further region-
specific information about exposure to radio waves (SAR), please see below:
USA, Guam, Puerto Rico & Virgin Islands (US, GU, PR, VI)
This device has been certified in compliance with the government´s
requirements for exposure to radio waves. In the United States and Canada, the
Extremity SAR limit for devices used by the public is 4 watts/kilogram (W/kg)
averaged over ten grams of body tissue. The standard incorporates a margin of
safety to give additional protection for the public and to account for any
variations in measurements. Before a device is available for sale to the
public in the US, it must be tested and certified by the Federal
Communications Commission (FCC) that it does not exceed the limit established
by the government adopted a requirement for safe exposure. The tests are
performed in positions and locations (i.e., by the ear and worn on the body)
as required by the FCC for each model. The FCC has granted an Equipment
Authorisation for this device with all reported SAR levels evaluated as in
compliance with the FCC RF exposure guidelines. While there may be differences
between the SAR levels of various devices, all devices granted an FCC
equipment authorization meet the government requirement for safe exposure. SAR
information on this device is on file at the FCC and can be found by entering
the FCC ID of your device at: transition.fcc.gov/oet/ea/fccid/. The FCC ID of
this device is: AK8VTG100 Carry this device at least 5 mm away from your body
to ensure exposure levels remain at or below the as-tested levels.
Canada
The available scientific evidence does not show that any health problems are
associated with using low-power wireless devices. There is no proof, however,
that these low-power wireless devices are absolutely safe. Low power Wireless
devices emit low levels of radiofrequency energy (RF) in the microwave range
while being used. Whereas high levels of RF can produce health effects (by
heating tissue), exposure of low-level RF that does not produce heating
effects causes no known adverse health effects. Many studies of low-level RF
exposures have not found any biological effects. Some studies have suggested
that some biological effects might occur, but such findings have not been
confirmed by additional research. This equipment has been tested and found to
comply with IC radiation exposure limits set forth for an uncontrolled
environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules.
IC: 409B-VTG100 Highest SAR value for EU for this device: 2.241 W/kg (10g),
0mm. Highest SAR value for USA/Canada (FCC/IC) for this device: 1.48 W/kg
(1g), 5mm..
Regulatory Information
Hereby, Sony Network Communications Europe B.V. declares that the radio equipment type VT-G100 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.compliance.sony.eu/ Hereby, Sony Network Communications Europe B.V. declares that the radio equipment type VT-G100 is in compliance with the relevant statutory requirements. The full text of the declaration of conformity is available at the following internet address: https://compliance.sony.co.uk Manufacturer: Sony Network Communications Europe B.V., Taurusavenue 16, 2132LS Hoofddorp, Netherlands EU Representative: Sony Europe B.V., Da Vincilaan 7-D1, 1930 Zaventem, Belgium UK Representative: Sony Europe B.V., The Heights, Brooklands, Weybridge, Surrey KT13 0XW, United Kingdom EU Importer: As stated on the product packaging. Supported frequency bands: LTE Cat-M1: Bands 1,2,3,4,5,8,12,13,18,19,20,26,28 EGPRS Quad band, Bluetooth LE. LTE :22.7dBm, EGPRS 30dBm, Bluetooth LE < 10mW
Waste Electrical and Electronic Equipment (WEEE)
**** This symbol means that according to local laws and regulations your
product and/or its battery shall be disposed of separately from household
waste. When this product reaches its end of life, take it to a collection
point designated by local authorities. Proper recycling of your product will
protect human health and the environment.
FCC
FCC ID:
AK8VTG100 This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by Sony may void the user’s authority to
operate the equipment. This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ISED (Canada)
IC: 409B-VTG100
This device contains license-exempt transmitters/receivers that comply with
Innovation, Science, and Economic Development Canada’s license-exempt RSS.
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Recycling
Lithium-ion batteries
Recycling Lithium-Ion batteries
Lithium-Ion batteries are recyclable
You can help preserve our environment by returning your used rechargeable
batteries to the collection and recycling location nearest you. For more
information information regarding the recycling of rechargeable batteries,
visit www.sony.com/ecotrade
Cation: Don not handle damaged or leaking Lithium-Ion batteries.
Open Source Software
This product contains open source software, for Copyright/license information
please visit: https://iot.sonynetworkcom.com/visilion/oss/
UPDATE BARCODE
UPDATE BARCODE NUMBERS
PART NUMBER AND REVISION FROM
PLM SYSTEM
References
- EMF - Welcome
- workcom.com/visilion/oss/
- EU Declaration of Conformity | Sony Ireland
- Sony Group Portal - Home
- Find a location to recycle your Sony product | Sony USA
- Sony Sustainable Development | Go Green Environmental Policy
- Gestión medioambiental | Huella ecológica y de carbono | Sony ES
- Visilion™ from Sony – OSS Sony
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>