Guangzhou Chihong Photoelectric Technology H7 Car LED Ambient Light Instructions
- June 6, 2024
- Guangzhou Chihong Photoelectric Technology
Table of Contents
Guangzhou Chihong Photoelectric Technology H7 Car LED Ambient Light
- Package list: 1 x Led strip lights ; 1 X DC line; 1X US port; 1X Car Charger; 8X double-sided tape.
- Plug in the plug, turn on the switch, and test the light with the APP controller.
- Tear off the protective film of the double-sided tape.
- Two light bars with shorter lines are attached to the bottom of the driver’s position, and the other two light bars are attached to the bottom of the front seat.
- Hide the route under the foot pad and plug the light and complete the installation .
Scan the QR code and download happy lighting, connect to Bluetooth, and refer
to the manual and connect the device.
Connect Bluetooth, open APP
Turn on 
Connect the device
If there’s problem Pis check the user guide
- Please try to turn off the switch button of the application, close the app and Bluetooth, then turn on them again.
- If the lights do not work after few days, pis try to turn off and turn on the switch button of the application and Bluetooth again; If they still don’t work, pis try to close the switch button of the application (and then close the APP), open the Bluetooth to cancel Pairing, and then turn off the Bluetooth. After waiting for 5 minutes, please turn on app’s and allow Bluetooth access, and they will work.
- Please wait 2-3 minutes for APP to work when the lights are not on, and it is not a quality issue.
PRODUCT INTRODUCTION
More Customer Service Support on FB: CIIHON AUTO LIGHT CLUB RGB FOG LIGHT
APP Name : Happylighting
Thank you for purchasing our product.
Please double-check the instructions before installation.
FCC Rules
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
The devices have been evaluated to meet general RF exposure requirement， the device can be used in portable exposure condition without restriction