Shenzhen Riguangyan Technology SQ11 Wifi Camera Instruction Manual

June 6, 2024
Shenzhen Riguangyan Technology

Shenzhen Riguangyan Technology SQ11 Wifi Camera

Shenzhen Riguangyan Technology SQ11 Wifi Camera-fig1

Download and install JXLCAM. IOS searches for “JXLCAM” download directly at the Apple App Store. For convenience, please scan the download and installation of the QR code below.
Note: during installation, all permissions of the JXLCAM APP need to be allowed, otherwise the APP will not work properly.

Open the list of mobile phones WIFI, connect to B/xCCQ…, open the APP page after success, click “AP” as shown in the figure below, and watch the video.

Note: when there is no WIFI in the environment, you can use AP mode to connect, which is valid for no more than 10m, which can achieve localized video viewing.

  • First confirm that there is a available WIFI near the device, turn on the device, flash the blue indicator light quickly, and the device is in a state to be connected. ( Note: WIFI signals supported only in the 2.4G band)
  • You can’t successfully distribute the network when the power is insufficient.
  • When wiring, please try to bring the device close to the router. When the nearby WIFI signal is weak, the image will be stuck if the network is not successful or the network is successful.
  • Open the APP and follow these steps:

Shenzhen Riguangyan Technology SQ11 Wifi Camera-fig4 Shenzhen Riguangyan Technology SQ11 Wifi Camera-
fig5

Shenzhen Riguangyan Technology SQ11 Wifi Camera-fig6 Shenzhen Riguangyan Technology SQ11 Wifi Camera-
fig7

Shenzhen Riguangyan Technology SQ11 Wifi Camera-fig9

Shenzhen Riguangyan Technology SQ11 Wifi Camera-fig12 Shenzhen Riguangyan Technology SQ11 Wifi Camera-
fig13

Shenzhen Riguangyan Technology SQ11 Wifi Camera-fig14

.
If you need to store video content, you need to install an SD card. This machine supports loop video recording

Shenzhen Riguangyan Technology SQ11 Wifi Camera-fig16

  1. When the device fails to congure the network, please check whether the router and WiFi password are congured correctly (the device does not support WIFI signals in the 5.8G band). After conrming that it is correct, you can press and hold the reset button until the device indicator ashes quickly, restore the factory settings, and recongure network.
  2. When the software homepage shows that the device is offline, you can check whether the device is normally powered on, and click the refresh icon in the upper right corner to refresh.
  3. The initial password of the device is admin.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals