Shenzhen Riguangyan Technology S9 WiFi Camera User Guide
- June 4, 2024
- Shenzhen Riguangyan Technology
Table of Contents
Shenzhen Riguangyan Technology S9 WiFi Camera
Appearance Guide
Charge
Please use a 500 -1000mA charger to charge the equipment. When charging, the blue indicator light is always on. When it is full, the blue indicator light is off.Can work while charging.
Turn on the device
Press the power button to start the device. After the device is started, the
red indicator blinks slowly and the device enters the waiting state.
Note: The red indicator blinks or is steady on. Hold down the mode button
for 5 seconds to reset.
Install APP
Download and install HDWifiCamPro, which is available from the apple store for
IOS and GooglePlay for Android. For easy installation, please scan the qr code
below to download the HDWifiCamPro installation. If your device cannot connect
to GooglePlay, please scan the APK QR code below to download and install it.
Note: during installation, you need to open all permissions of the APP,
otherwise the APP will not work properly. You are advised to use the QR code
scanning software of the browser to scan and download the APP.
Remote mode
Click “+” to configure a new camera to connect to wifi.
Note: When using the camera for the first time, please connect the mobile
phone to the 2.4g router first, and then follow the following steps to
configure the camera to connect to WIFI.
FAQ
-
Q1.Why can’t APP search detect camera/can’t configure network?
A:Please confirm that the device is connected properly and check whether the APP permission is restricted. -
Q2.Why does the camera always ask for a username and password, or an incorrect username?
A:The default password for the camera is 6666. If you forget the user name or password, you can restore the camera to factory Settings to get the original user name and password. -
Q3.How can I restore my camera to factory Settings?
A:Press the camera’s mode button for about 5 seconds until the camera is restarted.
Description of ICONS and buttons on the video page
FCC Caution
Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Information to user.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for Mobile device:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
withminimum distan ce 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>