Ubio ST-AB 3-in-1 Wireless Power Charging Station User Manual
- June 6, 2024
- Ubio
Table of Contents
Ubio ST-AB 3-in-1 Wireless Power Charging Station
Adapter
- INPUT AC 100-240V-50/60Hz
- OUTPUT DC 5V 3A MAX
STATION
- INPUT DC5VA-DC5V3
- OUTPUT DCVA/2A
- WATCH DC5V/0.5
- EARPHONE DC5V/0.5A
PART LIST
INSTALLATION NOTES
- Place The Phone Back vertically downwards
- Install the new knob
- Insert the watch charger into the base obliqely then press it down
- If you need to remove the watch charger just press the area at the bottom and then you could take off
- Align the phone and insert
- Also you can adjust phone holder to reach a suitable
- Put your watch on the charger
- Put your AirPods on the AirPods holder
Warm tips
-
- Reach us by amazon order detail page (Select order sold by or contact seller) for warranty about it
FCC WARNING
This device complies with part 15 Of the FCC Rules. Operation is subject to the fol owing two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful intefference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equiprnent into an Outlet on a circuit different from that to vW1ich the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>