Lifeplus CH-1500 Wall Mounted Garage Heater Instruction Manual
- June 6, 2024
- Lifeplus
Table of Contents
Lifeplus CH-1500 Wall Mounted Garage Heater
IMPORTANT:
Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Failure to do so could result in fire, electric shock, or serious personal injury. Keep this owner’s manual for future reference.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
-
Read all instructions before installing or using this heater.
-
CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater yourself.
-
This heater may get hot when in use. To avoid burns, DO NOT let bare skin touch hot surfaces. If provided, use handles when moving this heater. DO NOT place it against walls, furniture, curtains, etc.
-
Keep combustible materials, such as furniture, pillows, bedding, paper, clothes, and curtains at least 3 ft from the front of the heater and keep them away from the sides, top, and rear. DO NOT place towels or other objects on the heater.
-
Extreme caution is necessary when any heater is used.
-
DO NOT operate any heater with a damaged cord or after the heater malfunctions, has been dropped or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
-
This heater is not intended for use in bathrooms, laundry areas, showers or swimming pools and similar locations. NEVER locate heater where it may fall into a bathtub or other water container. To protect against electrical hazards, DO NOT immerse in water or other liquids.
-
DO NOT touch the control panel or plug with a wet hand.
-
DO NOT run cord under carpeting. DO NOT cover the cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over.
-
DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
-
To prevent a possible fire, DO NOT block the air intake or exhaust in any manner. DO NOT use on soft surfaces, like a bed, where openings may become blocked.
-
A heater has hot and arcing or sparking parts inside. DO NOT use in areas where gasoline, paint, explosive and/or flammable liquids are used or stored. Keep unit away from heated surfaces and open flames.
-
Always plug heaters directly into a wall outlet/receptacle. Never use an extension cord or relocatable power tap (outlet/power strip).
-
To avoid fire or shock hazards, plug the unit directly into a 120 V AC electrical outlet.
-
To disconnect the heater, turn controls to OFF, then remove the plug from the outlet. Pull firmly on the plug, DO NOT unplug by pulling on the cord.
-
Always unplug the unit before moving or cleaning, or whenever the heater is not in use.
-
Use only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by unauthorized dealers may cause hazards.
-
Always use on a dry surface.
-
Wall-mounted only. DO NOT use on ceilings.
-
WARNING: To reduce the risk of fire or electric shock,
DO NOT use this unit with any solid-state speed control device. -
DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user-serviceable parts
SPECIFICATIONS
Model Number | CH-1500 |
---|---|
Voltage | 120 V |
Rated Power | 1,500 W |
AMPS | 12.5 A |
SAFETY FEATURES
Overheat Safety Feature
This heater is equipped with an overheat safety feature. When the heater’s
internal components reach a certain temperature that could cause overheating
and possible fire, the heater will automatically shut off.
WARNING : This heater has a voltage rating of 120 volts. The cord has a
plug as shown in A. An adapter as shown in C is available for connecting
three-blade grounding-type plugs to two-slot receptacles. The ground-in plug
extending from the adapter must be connected to a permanent ground such as a
properly grounded outlet box. The adapter should not be used if a three-slot
grounded receptacle is available.
DO NOT DEFEAT THE SAFETY PURPOSE OF THE GROUNDED PLUG.
WARNING: It is normal for the power cord to feel warm to the touch; however, a loose fit between the outlet and the plug may cause overheating of the plug. If this occurs, try inserting the plug into a different outlet. Contact a qualified electrician to inspect the original outlet for damage.
IN THE BOX:
- Wall Mounted Garage Heater
- 1 x Mounting Bracket 3 x ST 4*35 Screws
- 2 x M4*25 Screws 3 x Wall Anchors
- 1 x Metal Washer 2 x Nuts
PRODUCT DIAGRAM
INSTRUCTIONS FOR ASSEMBLY
KEY SLOT MOUNTING INSTALLATION
WARNING: The heater should be at least 3 feet away from combustible material.
The heater is wall mounted only, not suitable for ceiling mounting.
-
Locate the desired position on your wall in the area to be warmed. Ensure the unit can fit in a horizontal orientation position. Unit MUST be near an outlet. Unit CAN NOT be near electrical
cables, communication lines, pipes, combustible materials, etc. That could be damaged or ignited by excessive heat. -
Using the Mounting Bracket as a template, line up one of the key slots at each end of the bracket. Mark the 3 slotted openings.
-
Predrill your wall based on the above markings and insert 3 Wall Anchors.
-
Install 3 x ST4*35 Screws and 1 x Washer provided, leaving about 1/4 inch between the head of the screws and the mounting surface.VB Slip the Mounting Bracket over the screw heads and slide the bracket to engage the screws in the slots. Tighten the Screws securely. See Fig. 1
`
ATTACHING HEATER TO MOUNTING BRACKET
WARNING: Always remove the Screw from each Rotating Arm before attaching heater to Mounting Bracket. Do not forget to put the Screws back in each Rotating Arm after attaching the heater. Otherwise, the heater could slide out of Mounting Bracket and cause injury or damage.
- The heater is equipped with Rotating Arms at each end of the unit. To conserve space in shipment, these arms are in line with the heater body and must be repositioned before installation. With your heater laying face down, rotate each arm slowly upward until they are perpendicular to the body. For safety reasons, once rotated, the arms cannot be returned to their original position.
- Holding the heater by the Rotating Arms (one in each hand), slide the Rotating Arms onto the Mounting Bracket until it locks into place.
- Place the 2 x M4*25 Screws into each Rotating Arm with the nut after the heater is attached to the Mounting Bracket. See Fig. 2
- Plug the unit directly into a 120V AC grounded outlet. Keep the cord away from the front of the heater. Do not use an extension cord, because the extension cord may overheat and cause a risk of fire.
CAUTION: Do not adjust the heater while it is operating. The metal parts of the housing and the lampshade get very hot and can cause injury. Always turn your heater off and allow time for it to cool before adjusting.
REMOVING HEATER FROM MOUNTING BRACKET
- Unplug the unit and let it cool completely.
- Remove Screws from each Rotating Arm.
- Push in the two-arm release button on the side of each arm.
- Grasp both arms and simultaneously pull the unit down while holding the buttons in.
INSTRUCTIONS FOR USE
-
With the power set at Off Position, plug the heater directly into a 120V AC grounded outlet.
-
Rotate the heater to the desired direction.
-
Set the heat function by pulling the pull string. See power indicator as below:
Position 0: OFF Position
The position I: 1 Watt, lighting only
Position II: 750 Watts, light and one heating element
Position III: 1500 Watts, light and both elements
- Set the power to OFF Position and unplug the heater when finished using.
NOTICE: When the heat function is used for the first time, a slight odor may be present. This is normal and should not occur again unless the heater is not used for an extended period of time.
CAUTION: Do not attempt to remove the heater one arm at a time. Do not attempt to fold this heater. These could cause damage to the heater housing.
MAINTENANCE
- Set the power to OFF Position.
- Unplug the unit and let it cool completely.
- To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. A mild detergent can be used if necessary
- After cleaning, dry the unit with a soft cloth.
- Wait until the unit is completely dry before use.
WARNING:
- DO NOT let liquid enter the heater.
- DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater.
- DO NOT immerse the heater in water.
STORAGE:
Store the heater in a cool, dry location when not in use. To prevent dust
and dirt build-up, use the original packaging to repack the unit.
TROUBLESHOOTING
If the heater will not operate, please check the following:
- Check if the power cord is plugged into an electrical outlet. If not, plug-in unit to appropriate outlet.
- Check if electricity to the outlet is working
- Ensure power is turned to ON position.
- See the SAFETY FEATURES section for additional information.
NOTICE : The product is equipped with an overheat safety feature protector which will switch off the heater in case of accidental over heating (ex. Obstruction of air intake and outlet grills).
LIMITED MANUFACTURER WARRANTY
1 Year Limited Warranty: Lifeplus warrants this heater against defects in materials and workmanship on functional parts, for a period of one year from the original date of purchase. Your sales receipt showing the date of purchase of the product is your proof of purchase. Keep it in a safe place for future reference.
Manufacturer Warranty
All Lifeplus products are manufactured with the highest quality materials and
are warranted to be free from defects in material and workmanship at the time
of purchase. This limited warranty applies to products manufactured or
distributed by the Lifeplus brand name, are delivered in the continental
United States, and extend to the original purchaser, or gift recipient. This
warranty becomes valid at the time of purchase and terminates either by the
specified time frame listed above and/or owner transfer (unless otherwise
authorized by model no.CH-1500
Lifeplus, as the manufacturer). Any extended warranties (warranties that cover
above and beyond this manufacturer warranty) that are sold through a retailer
or third party, are not directly correlated with this Lifeplus limited
warranty and may be redirected to said retailer or third party for coverage.
Some States do not allow limitations on how long an implied warranty lasts, so
the above limitation may not apply to you.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to
you.
This warranty gives you specific legal rights, and you may also have other
rights which vary from State to State.
The purchaser must present Lifeplus with proof of purchase documents
(including the date of purchase) if requested. Any evidence of alteration,
erasing, or forgery of proof of purchase documents will be just caused to VOID
this limited warranty. Products, in which the serial number has been defaced
or removed, are not eligible for warranty coverage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>