Honwa HW-TE41-BE-TA Wireless Bluetooth Earbuds Instruction Manual
- June 6, 2024
- Honwa
Table of Contents
Products Manual
Thank you for purchase and use our Wireless Bluetooth Earphone. In order to have a proper and safer use of the headset, please read this user manual in detail and save it.
Product description
Device requirement: Compatible with most Bluetooth-enabled devices Support voice prompts Support some IOS systems and Android system to display current battery BT mode: AVRCP/A2DP/HFP/HSP/SPPV Wireless frequency: 2402MHz-2480MHz Receiving range: 10M (barrier free space) Working temperature: -20°C to 40°C
Charging method
Please use the original charging cable
Charging voltage: 5v/100mA-300mA. Red indicator turns on when charging, if full charged blue indicator turns on or all lights turn off. Flashing red when low battery.
Instruction
Open: press key about 3 seconds until the light turn on with the audio
reminding.
Close: press key about 3 seconds until the red light turn on with the audio
reminding.
Pairing: press key a few seconds, after a few seconds of poweron , the
earphone will automatically enter the pairing mode and voice prompt, thus
entering the being searched state.
Pairing connection: open the Bluetooth device to search the earphone. Press to
connect, if pairing, will show “connected” on the device.
Play and stop: single press key to play or stop the music.
Previous song: long press key 2 seconds
Next song: long press key 2 seconds
Volume up: click key
Volume down: click key
Answer or End call: click key
Last call redial: double click key
Reject call: long press key about 2 seconds
Warning
Do not put this product in high temperature environment
Do not immerse this product into water.
Keep this product away from fire.
Please use the product standard USB charging line.
Do not over charge the product continuously, result in affecting the product
service life.
This product contains a lithium ion polymer core, is strictly prohibited to
disassemble the product shell, to avoid damage to the product and may cause
damage or other dangerous electrical core.
FCC Warning Statement Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment. This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>