NOKIA TA-1341 5G Dual 128Gb Smart Phone User Guide

June 6, 2024
Nokia

Get Started
Nokia xx

NOKIA TA-1341 5G Dual 128Gb Smart Phone

*Google Assistant is not available in certain languages and countries. Where not available, Google Assistant is replaced by Google Search. Check availability at https://support.google.com/assistant.

Insert the SIM and memory card

  1. Open the SIM card tray: push the tray opener pin in the tray hole and slide the tray out.

  2. If you have a single-SIM phone, put a nano-SIM card in slot 1 and a memory card in slot 2 on the tray with the contact areas face down. If you have a dual-SIM phone, put a nano-SIM card in slot 1 and either a second SIM or a memory card in slot 2 with the contact areas face down.
    Tip: To find out if your phone can use 2 SIM cards, see the label on the sales box. If there are 2 IMEI codes on the label, you have a dual-SIM phone.

  3. Slide the tray back in.
    Use only original nano-SIM cards. The use of incompatible SIM cards may damage the card or the device and may corrupt data stored on the card. Use only compatible memory cards approved for use with this device. Incompatible cards may damage the card and the device and corrupt data stored on the card.
    Important: Do not remove the memory card when an app is using it. Doing so may damage the memory card and the device and corrupt data stored on the card. Both SIM cards are available at the same time when the device is not being used, but while one SIM card is active, for example, making a call, the other may be unavailable.

Note: 5G may not be available when two SIM cards are inserted into your phone. If you have two SIM cards inserted, both SIM cards support 4G/3G/ 2G. For more information on your SIM cards, contact your service provider.

NOKIA TA-1341 5G Dual 128Gb Smart Phone - SIM card

Charge the battery and switch the phone on

Plug a compatible charger into a wall outlet, and connect the cable to your phone. Your phone supports the USB-C cable. You can also charge your phone from a computer with a USB cable, but it may take a longer time.
If the battery is completely discharged, it may take several minutes before the charging indicator is displayed.
To switch your phone on, press and hold the power key until the phone vibrates. The phone guides you through the setup.

For an online user guide and troubleshooting help, go to www.nokia.com /mobile-support.

Product and safety info

Important: For important info on the safe use of your device and battery, read the Product and safety info booklet before you take your device into use.
You can only use your device on the GSM 850, 900, 1800, 1900;
WCDMA 1, 2, 4, 5, 8; LTE 1, 2, 3, 4, 5, 7, 8, 12, 20, 28, 38, 39, 40, 41, 66; 5G NR: n1, n2, n3, n5, n7, n28, n38, n41, n66, n78 networks.
You need a subscription with a service provider.
Important: 4G/LTE might not be supported by your network service provider or by the service provider you are using when traveling. In these cases, you may not be able to make or receive calls, send or receive messages or use mobile data connections. To make sure your device works seamlessly when full 4G/LTE service is not available, it is recommended that you change the highest connection speed from 4G to 3G. To do this, on the home screen, tap Settings > Network & Internet > Mobile network > Advanced, and switch Preferred network type to 3G.
For more info, contact your network service provider.

Maximum transmit power

GSM 850, 900 35 dBm
GSM 1800, 1900 32 dBm
WCDMA 1, 2, 4, 5, 8 25 dBm
LTE 1, 2, 3, 4, 5, 7, 8, 12, 20, 28, 38, 39, 40, 41,66 25 dBm
5G NR: n1, n2, n3, n5, n7, n28, n38, n66 24 dBm
5G NR: n41, n78 25 dBm
Bluetooth® 9.85 dBm
WLAN 2.4G 16.31 dBm
WLAN 56 16.99 dBm
NFC -19.78 dBuA/m

Your device has an internal, non-removable, rechargeable battery.
Do not attempt to remove the battery or back cover, as you may damage the device. To replace the battery, take the device to the nearest authorized service facility.

Charge your device with the 1-CHEUQ302-095 (EU plug) /
1-CHUKQ302-096 (UK plug) / 1-CHUSQ302-097 (US plug) /
1-CHAUQ302-099 (Australia plug) chargers. HMD Global may make additional battery or charger models available for this device.
Charging time can vary depending on device capability. Some of the accessories mentioned in this user guide, such as charger, headset, or data cable, may be sold separately.
When the charger is not included in the sales box, charge your device using the data cable (included) and a USB power adaptor (may be sold separately).
You can charge your device with third-party cables and power adaptors that are compliant with USB 2.0 or later and with applicable country regulations and international and regional safety standards.
Other adaptors may not meet applicable safety standards, and charging with such adaptors could pose a risk of property loss or personal injury. It is recommended to use a power adaptor with an input of 100-240V~50/60Hz 0.5A and an output of 9.0V/2A to optimize the charging of your device.
The surface of the device is nickel-free.
Parts of the device are magnetic. Metallic materials may be attracted to the device. Do not place credit cards or other magnetic stripe cards near the device for extended periods of time, since the cards may be damaged.

Note: Pre-installed system software and apps use a significant part of memory space.
Keep a safe distance when using the flash. Do not use the flash on people or animals at close range. Do not cover the flash while taking a photo.

Note: The device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency range in the following countries:

AT BE BG HR CY CZ DK
EE Fl FR DE EL HU IE
IT LV LT LU MT NL PL
PT RO SK SI ES SE UK

Certification information (SAR)
This mobile device meets guidelines for exposure to radio waves as set forth by the Council of Europe (CE). Refer to the following.

European RF Exposure Information
Your mobile device is a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves recommended by international guidelines. These guidelines were developed by the independent scientific organization ICNIRP and include safety margins designed to assure the protection of all persons, regardless of age and health.
The guidelines use a unit of measurement known as the Specific Absorption Rate or SAR.
The SAR limit for mobile devices is 2.0 W/kg and the highest SAR value for this device when tested at the ear is 0.51 W/kg. As mobile devices offer a range of functions, they can be used in other positions, such as on the body. In this case, the highest tested SAR value is 1.29 W/kg at the separation distance of 0.5 cm from the body.

For electronic safety, maintain the separation distance with accessories containing no metal, which positions the handset a minimum of the above distance. The use of other accessories may not ensure compliance with RF exposure guidelines.
*The tests are carried out in accordance with international guidelines for testing.
This mobile device meets guidelines for exposure to radio waves as set forth by the Federal Communications Commission (FCC). Refer to the following.

FCC RF Exposure Information
Your handset is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluations of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless handsets employs a unit of measurement known as the Specific Absorption Rate or SAR. The SAR limit set by the FCC is 1.6 W/kg. The tests are performed in positions and locations (e.g. at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this handset model as reported to the FCC when tested for use at the ear is 1.04 W/kg, and when worn on the body in a holder or carry case, is 0.62 W/kg.
Body-worn Operation; This device was tested for typical body-worn operations with the handset kept 1.0 cm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 1.0 cm separation distance between the user’s body and the handset. The use of belt clips, holsters, and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements and should be avoided. The FCC has granted an Equipment Authorization for this handset model with all reported SAR levels evaluated as in compliance with the FCC RF emission guidelines. SAR information on this handset model is on file with the FCC and can be found under the FCC ID Search section of www.fcc.gov/oet/ea/ after searching on FCC ID 2AJOTTA-1341 or 2AJOTTA-1344.
Additional information on Specific Absorption Rates (SAR) can be found on the FCC website at www.fcc.gov/general/radio- frequency safety-0. To send data or messages, a good connection to the network is needed. Sending may be delayed until such a connection is available. Follow the separation distance instructions until the sending is finished.
During general use, the SAR values are usually well below the values stated above. This is because, for purposes of system efficiency and to minimize interference on the network, the operating power of your mobile is automatically decreased when full power is not needed for the call. The lower the power output, the lower the SAR value.
Device models may have different versions and more than one value.
Component and design changes may occur over time and some changes could affect SAR values.
For more info, go to www.sar-tick.com.
Note that mobile devices may be transmitting even if you are not making a voice call.
Your mobile device is also designed to meet the United States
Federal Communications Commission (FCC) guidelines.
FCC ratings for your device and more information on SAR can be found at http://transition.fcc.gov/oet/rfsafety/sar.html.
The World Health Organization (WHO) has stated that current scientific information does not indicate the need for any special precautions when using mobile devices. If you are interested in reducing your exposure, they recommend you limit your usage or use a hands-free kit to keep the device away from your head and body.
For more information and explanations and discussions on RF exposure, go to the WHO website at www.who.int/peh-emf/en.

Copyrights and other notices
EU Declaration of Conformity

Hereby, HMD Global Oy declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. A copy of the
EU Declaration of Conformity can be found at https://www.nokia.com/en_int/phones/declaration-of-conformity.
FCC Notice: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
For more info, go to www.fcc.gov/engineeringtechnology/electromagnetic- compatibility-division/radiofrequency-safety/faq/rf- safety.
Any changes or modifications not expressly approved by HMD Global could void the user’s authority to operate this equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.
    This device has an electronic label for certification information. To access it, select Settings > System > Certification

© 2021 HMD Global. HMD Global Oy is the exclusive licensee of the
Nokia brand for phones & tablets. Nokia is a registered trademark of Nokia Corporation.

Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries.
Qualcomm is a trademark or registered trademark of Qualcomm
Incorporated. aptX is a trademark or registered trademark of Qualcomm Technologies International, Ltd.
Android, Google, and other related marks and logos are trademarks of Google LLC.
ZEISS and the ZEISS logo are registered trademarks of Carl Zeiss AG used under the license of Carl Zeiss Vision GmbH. OZO is a trademark of Nokia Technologies Oy.

The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by HMD Global is under license.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals