Shenzhen Hanruike Technology EN-C6PLUS Outdoor Speaker User Manual
- June 6, 2024
- Shenzhen Hanruike Technology
Table of Contents
Shenzhen Hanruike Technology EN-C6PLUS Outdoor Speaker User Manual
1. Accessory
2. Illustration
- Short press: Play/ Pause /Answer phone /Hand up phone Long press ON phone voice Double click Reject phone
- Long press Power ON/OFF Short press LED light mode Double click: ON/ OFF TWS mode
- Charging Port
3. Specifications
4. Function Key
5. LED Indicator
- RGB LED blinks when the speaker waiting for connection, and turns solid blue after Bluetooth connected successfully.
- RGB LED turns solid red when the speaker is recharging, and turns off after the battery fully recharged.
6. Bluetooth Pairing
- Power on speaker the RGB LED will blinks, go to Bluetooth setting on your device, find EN-C6 PLUS and select to pair.
What is TWS
- TWS means true wireless stereo, Let’s say two Bluetooth speakers are able to paired and playing music synchronously.
How to pair your device?
- Please make sure these two speakers to be paired disconnect from your bluetooth device before you turn them on.
- Select any one of speaker and double click the POWER key . You will hear are mind sound, the speaker is waiting for TWS paring.
- When enter into the matching mode with the voice prompt, the RGB led light on the two speakers will be bright in the mean time the light control on the main-speaker is normal and the yellow light bighting on the sub-speaker.
- Select the searching mode on your device, When your device finds “EN-C6 PLUS”, select it and connect.
- They will perform as the stereo sounding system.
- Once the speakers are well paired at the first time, they will be automatically paired next time without the above pairing operation.
- If the speaker used to be paired, it’s suggested to press “POWER” button for 8 seconds to for forcibly cut off the power. Then restart and have the same speakers-paired with the required new speaker according to the above instruction item 1-item 5.
Made in China
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>