BLACK+DECKER BHDC500B46 3 Settings Ceramic Electric Heater Instruction Manual
- June 3, 2024
- BLACK+DECKER
Table of Contents
BLACK+DECKER BHDC500B46 3 Settings Ceramic Electric Heater
Introduction
With its functionality and ease of use, this portable ceramic heater from BLACK+DECKER is the best electric heater for indoor usage. Take advantage of the portable heater’s small size (7.5″ x 6.3″ x 9.5″) and light weight (2.75 lbs.) to bring it wherever you go. This is a simple heater that may be used in a bedroom or office. Wherever your new personal heater is most needed is up to you. Fan, Low (900 Watts), and High are the 3 best heat settings for you to choose from (1500 Watts). Rest assured that this great heater fan has safety overheat prevention and even a tip-over auto shutdown feature if you’re concerned about safety. Without fretting, keep warm.
Enjoy the little electric fan’s manual thermostat adjustment. It is easy, simple, and intuitive to use your BLACK+DECKER space heater in the room of your choosing thanks to the 6 ft. power connection and the power on indicator light. 120V/60Hz. Enjoy the features, advantages, and benefits of this incredible black space-saving space heater with thermostat while staying toasty and comfortable.
SPECIFICATIONS
- VOLTAGE: 120V, 60Hz
- POWER CONSUMPTION: 1500W
- UNIT SIZE (WXDXH): 5″ x 5.7″ x 9.2″
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
- Read all instructions before using this heater.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the heater and keep them away from the sides and rear.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
- Always unplug heater when not in use.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater or return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
- Do not use outdoors
- This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fail into bathtub or other water container.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- To disconnect heater, first turn controls to off, then remove plug from outlet.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
- To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
- A heater has hot and arcing or sparking parts inside. Do not use it in the areas where gasoline, paint, or flammable liquids are used or stored.
- Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
- This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater into a circuit that already has other appliances working.
- The output of this heater may vary and its temperature may become intense enough to burn exposed skin. Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to avoid burns.
- Don’t leave the heater unattended
SETUP AND US E
PARTS AND FEATURES
OPERATING INSTRUCTIONS
Place the heater on a firm, level surface and plug the unit directly into a 120 V AC electrical outlet.
NOTE: Only operate heater in upright position.
- Turn the heat control knob clockwise (right) from the OFF position to the Low or HIGH (1500 watts) heat settings. For Fan Only operation without any heat turn to the FAN setting.
- To adjust the thermostat, turn the thermostat knob clockwise (right) from the MIN position to the MAX position to increase the temperature. When the desired temperature is reached lower the thermostat setting until the heater stops operating by turning the thermostat knob to the MIN position. The power indicator light turns on when either the, FAN, LOW or HIGH setting is selected.
NOTE: Turning the THERMOSTAT control knob clockwise will increase the temperature setting.
Turn the fan/heat control knob to “OFF” to shut off the unit.
CARE AND CLEANING
MAINTENANCE
- Turn power off before cleaning.
- Unplug the unit and let it cool completely.
- To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.
CAUTION: DO NOT let liquid enter the heater.
- DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater
- DO NOT immerse the heater in water.
- Wait until the unit is completely dry before use.
STORAGE
Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the original packaging to repack the unit.
TROUBLESHOOTING
BEFORE YOU CALL FOR SERVICE
IF THE HEATER/FAN FAILS TO OPERATE:
- Check to make sure that the heater/fan is plugged in securely. If it is not, remove the plug from the outlet, wait 10 seconds and plug it in again securely.
- Check for a blown circuit fuse or a tripped main circuit breaker. If these seem to be operating properly, test the outlet with another appliance.
- Check if electricity to the main power switch in the back of the unit appears to be working.
- Make sure the heater is in the upright position.
NOTE: For the heater to function properly, the desired temperature on the heater must be set a few degrees higher than the temperature in the room. If the unit seems to not be heating properly, increase the desired temperature on the heater to fully engage the heating elements.
If none of the above solves the problem, contact a qualified technician. Do not try to adjust or repair the heater/fan yourself.
FAQs
What are the approximate dimensions (as close as possible) of this heater at its three widest points, height, width and thickness?****
9″ tall; 7.5″ wide; 6.5″ deep.
Does it have a function to heat without fan/blowing air?****
No; this is a ceramic heater which uses a fan to distribute heat, just like regular fan forced heaters. You might want to try an infrared or convection heater, though I can’t speak on how well they work.
Does this heater heat lower towards the floor?****
Because it is very small, it sits very close to the floor. So, I would say yes. I use it on the floor in front of my couch to warm my feet.
Is there a fan only setting which will blow no heat? I also do not want the heat to be thermostat controlled, I want it to blow constantly.****
Yes, on the fan blowing with no heat & I’ve had mine on most of the winter on high; just shuts off when I turn it off.
Does the heater use less power on low setting? i.e. less than 1500 watts?****
750 watts on low setting.
Do you need to unplug it even with both dials are set to zero?****
it’s not a need.
Does this heater heat closer to the ground area?****
It heats close to the ground, and has a heating element that will shut off automatically when the incoming air is already at sufficient temperature or when the unit is picked up or tipped over. I tipped this over on purpose a few times because I am skeptical about things that produce heat and cause fires. It turned off every time.
I need something to heat up the bathroom I am old and sick and need extra heat to take a shower****
I think this could do very well in that kind of confined space. Maybe heat up the bathroom first and then turn it off and unplug it (and possibly even put it outside the bathroom while showering) so that steam doesn’t cause an issue with it.
Does this particular heater have to be plugged I?****
It must be plugged in to work.
how long is the power cord?****
At least 6 ft.
How much sq. ft does it heat up?****
My office is about 10x 10 sq. ft, it is heavily AC-ed so I bought this to keep myself warm. I usually use “low” setting it warms up the space quickly if the door is closed. It works really well.
Can I use a smart plug with it?****
Yes, I don’t think that would present a problem.
does it have overheating shut off?****
Yes, it has both an overheating shut off feature and tip over shut off feature.3