beko CTB 6407 W Built-in Hood User Manual
- June 6, 2024
- Beko
Table of Contents
beko CTB 6407 W Built-in Hood
Important Safety and Environmental Instructions
General Safety
-
Important Safety Instructions Read Carefully And Keep For Future Reference This section contains safety instructions that will help protect from risk of fire, electric shock, exposure to leak microwave energy, personal injury or property damage. Failure to follow these instructions shall void any warranty.
-
Beko products comply with the applicable safety standards; therefore, in case of any damage on the appliance or power cable, it should be repaired or replaced by the dealer, service center or a specialist and authorized service alike to avoid any danger. Faulty or unqualified repair work may be dangerous and cause risk to the user.
-
This appliance is intended to be used in households and similar ap-plications such as:
-
Staff kitchen areas in shops, offices and other working environments;
-
Farmhouses
-
By clients in hotels, and other residential type environments;
-
Bed and Breakfast type environments.
-
Operate the appliance for its in-tended purpose only as described in this manual.
-
The manufacturer cannot be held liable for damages resulting from improper installation or misuse of the product.
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental ca-pabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way understand the hazards involved.
-
Children shall not be allowed play with the appliance. Cleaning and user maintenance shall not be made by children without super-vision.
-
The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of your product must be at least 65 cm.
-
If the instructions for installation for the gas hob specify a greater distance, this has to be taken into account.
-
Make sure that your mains power supply complies with the information supplied on the rating plate of the appliance.
-
Never use the appliance if the power cable or the appliance it-self is damaged.
-
Prevent damage to the power cable by not squeezing, bending, or rubbing it on sharp edges. Keep the power cable away from hot surfaces and naked flame.
-
Use the appliance with a grounded outlet only.
WARNING: Do not connect the appliance to the mains until the installation is fully complete. -
Place the appliance in a way so that the plug is always accessible.
-
Do not touch the lamps if they have operated for a long time. They can burn your hands since they will be hot.
-
Follow the regulations set out by competent authorities on the discharge of the exhaust air (this warning is not applicable for use without flue).
-
Operate your appliance after putting a pot, pan, etc. on the hob. Otherwise, high heat may cause deformation in some parts of your product.•
-
Turn off the hob before taking the pot, pan, etc. from it.• Do not leave hot oil on the hob. Pans with hot oil may cause self-combustion.
-
Pay attention to your curtains and covers since oil may
-
catch fire while cooking food such as fries.
-
The grease filter must be replaced at least monthly. The carbon filter must be replaced at least every 3 months.
-
The product shall be cleaned accord-ance with the user manual. If the cleaning was not carried out in accordance with user manual, there may be fire risk.
-
Do not use non-fire-resistant filtering materials instead of the current filter.
-
Only use the original parts or parts recommended by the manufacturer.
-
Do not operate the product without the filter and do not remove the filters while the product is running.•
-
In the event of being started any flame, de-energize your product and cooking appliances.
-
In the event of being started any flame, cover the flame and never use water to extinguish.
-
Unplug the appliance before each cleaning and when the appliance is not in use.•
-
The negative pressure in the environment should not exceed 4 Pa (4 x 10 bar) while the hood for electric hob and appliances running on another type of energy but electricity operates simultaneously.
-
In the environment where the appliance is being used, the exhaust of devices running on fuel oil or gas, such as room heater must be absolutely isolated or the device must be hermetical type.
-
When connecting the flue, use pipes with a diameter of 120 or 150 mm. The pipe connection must be as short as possible and have a few elbows as possible. The danger of choking! Keep all the packaging materials away from children.
CAUTION: Accessible parts may become hot when used with cooking appliances. -
The product outlet must not be connected to air channels that include other smoke.•
-
The ventilation in the room may be insufficient when the hood for the electric hob is used simultaneously with the devices operating on gas or other fuels (this may not apply to appliances that only dis-charge the air back into the room).
-
Objects placed on the product may fall. Do not place any objects on the product.
-
Do not flambe under your product.
WARNING: Before installing the Hood, remove the protective films. -
Never leave high naked flames under the hood when it is in operation
-
Deep fat fryers must be continu-ously monitored during use: overheated oil can burst into flames.
Compliance with the WEEE Directive and Disposing of the Waste Product:
- This product complies with EU WEEE Directive (2012/19/EU). This product bears a classification symbol for waste electrical and electronic equipment (WEEE).
- This symbol indicates that this product shall not be disposed of with other household wastes at the end of
- its service life. Used devices must be returned to official collection point for the recycling of electrical and electronic devices. To find these collec-tion systems please contact to your local authorities or retailer where the product was purchased. Each household performs an important role in recovering and recycling of old appliances. Appropriate disposal of used appliances helps prevent potential negative consequences for the environment and human health.
Compliance with RoHS Directive
- The product you have purchased complies with EU RoHS Directive (2011/65/EU). It does not contain
- harmful and prohibited materials specified in the Directive.
Package Information
- Packaging materials of the product are manufactured from recyclable materials in accordance with our National
- Environment Regulations. Do not dispose of the packaging materials together with the domestic or other wastes. Take them to the packaging material collection points designat-ed by the local authorities.
General Appearance
Overview
- Main Body
- Aluminum Grease filter
- Lighting
- Control Panel
- Chimney
Technical Data
Model| CTB 6407 XH / CTB 9407 X / CTB 6407 W / CTB 6407 X
/ DT 312 W / DT 312 I
---|---
Supply Voltage| 220-240V ~ 50 Hz
Lamp Power (W)| 2×4
Motor Power (W)| 1 x 125
Air Flow (m³/h) – 3. Level| 310
Insulation Class| CLASS II
Using the Appliance
Controls Panel
- The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells.
- Never use the hood for purposes other than for which it has been designed.
- Never leave high naked flames under the hood when it is in operation.
- Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides.
- Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames.
Lamp Replacement
- Candle type LED lamp is used in this product
- Max 4 W lamp must be used when the change of lamp
Cleaning and maintenance
Prior to cleaning and maintenance, unplug the appliance or turn the main
switch off or loosen the fuse that supplies the hood.
CAUTION Failure to comply with the provisions relating to the cleaning of
the device and replacement of filters may cause fire risks. It is therefore
recommended to comply with the guidelines given herein. The manufacturer is
not liable for any damage to the engine or fires caused by improper use.
Clean using only a cloth dampened with neutral liquid detergent. Do not clean
with tools or instruments. Do not use abrasive products. Do not use alcohol
Cleaning of Aluminium Grease Filter
This filter captures oil particles in the air. You are This filter captures
oil particles in the air. You are recommended to clean your filter every month
under normal usage conditions. First, remove the grease filters for this
process. Wash the filters with liquid detergent and rinse them with water and
install them back after they get dry. Aluminum grease filters may get
discovered as they are washed; this is normal and you don’t need to change
your filter You can wash the Aluminum filter in the dishwasher
Changing of Carbon Filter (Air Circulation Mode)
The hood can be fitted with an active carbon filter. The carbon filter is
applied only in case the hood is not connected to the vent duct.
In any case, it is necessary to replace the carbon filter at least every three
months.
WARNING : The carbon fil-ter is never washed.
Setting Up the Device
WARNING: Please read saffety instruc-tions before setting up
5.1 Installation Accessories
- Hood
- Air Outlet Grille
- Closing Element (Optional)
- 4 X 4,2 X 44,4 Screws
- 2 X 4,2 X 12,7 Screws
- 2 X 2,9 X 12,7 Screws
- User Manual
Troubleshooting
Troubleshoo- ting | Reason | Help |
---|---|---|
The product does not work. | Check your fuse. | Your fuse might be closed, make |
it work.
The product does not work.| Check the electrical connec- tion.| The mains
voltage should be between 220-240 V.
The product does not work.| Check the electrical connec- tion.| Check if the
other pro- ducts in your kitchen are working or not.
The lighting lamp does not work.| Check the electrical connec- tion.| The
mains voltage should be between 220-240 V.
The lighting lamp does not work.| Check the lamp switch.| The lamp switch
should be in the “on” position.
The lighting lamp does not work.| Check the lamps.| The lamps of the product
should not be faulty.
The air intake of the product is poor.| Check the aluminum filter.| The
aluminum oil fil- ter should be cleaned at least once a month under normal
condi- tions.
The air intake of the product is poor.| Check the air vent flue.| The air vent
flue should be in the ”on” position.
The air intake of the product is poor.| Check the carbon filter.| For products
with carbon filters, the filter should normally be changed every 3 months.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>