adamm-RSM QSG-A0002 Wearable Asthma Monitoring User Guide
- June 6, 2024
- adamm-RSM
Table of Contents
Quick Start Guide
How to Use ADAMM-RSM
You should have
|
---|---
Quick Reference for using ADAMM-RSM
1. ‘ON’ Check Button
2. Power Button
3. Wi-Fi Sync Button
4. Indicator Light Indicator| 5. Light
6.Charging Contacts
7. Indicator Light
---|---
Turning ON and Turning OFF ADAMM-RSM
- Turning ON: Press and hold
**2**for**4**seconds and then release.**5**blinks blue and then green as it powers UP. - Turning OFF: Press and hold
**2**until the device vibrates (approximately 10 seconds) and release as soon as the device starts to vibrate. If**5**lights up during this time, stop and repeat in one minute. - Reset If Not Turning ON: Press and hold
**2**for 20 seconds. If**5**lights up during this time, stop the reset, as the light means the device is now turning ON.
Tip: A vibration will occur when you press**1**if the device is ON.
Applying the Adhesives
-
Hold the clear liner and peel the white liner away from the adhesive pad.
-
Hold the clear liner and match the adhesive shape with the device.
-
Press the adhesive pad onto the device as shown.
-
Peel the clear liner off without lifting the adhesive off the device.
Placing Device on Body
Place the ADAMM-RSMTM wearable anywhere on the upper torso (the area below the
base of the neck and above the stomach on the front, side, or back).
Tip: Do not slouch when sticking on the ADAMM-RSM.
Tip : Figure out a few comfortable positions to wear the ADAMM-RSM and
alternate wearing it in those positions from day to day.
Charging
-
Remove any adhesive from the back of the wearable.
-
Place the wearable in the charging cradle with the gold points lined up as shown.
Close the cradle and secure it with the strap. -
Make sure the cradle is connected to the wall adapter and the wall adapter is plugged into the electrical outlet.
NOTE: Only use the provided USB Adapter. -
The indicator light
**7**will light on the wearable (it may take a few seconds). If the lights do not show, power ON the wearable. Reset if required.- Flashing RED – indicates the wearable is charging
- Steady RED – indicates the wearable is fully charged
-
The device should NEVER be worn while charging.
Wi-Fi Syncing
- Press the wi-fi sync button
**3**to enable Wi-Fi Sync feature on the ADAMM-RSMTM device. During this time the indicator light**4**will flash BLUE in color.
NOTE: Use Wi-Fi to upload data to cloud nightly or at least a few times a week.
**QSG-A0002
**
Office: 585-471-8215
Email:
clinicaltrials@healthcareoriginals.com
1 Pleasant St, Ste 442
Rochester, NY 14604 USA