Runnatal RS0003-2-B Gas Water Heater Installation Guide

Runnatal RS0003-2-B Gas Water Heater

Open the packing carton. Check water heater main unit & accessories.

Check room layout and confirm suitable installing solution

Kindly note that this model is designed for indoor use, there are two solutions for installing.

A hole (Φ 70mm) is required on the wall to make exhaust pipe through. If there is no hole with good size on the wall, the drilling work needs to be completed by professionals using professional tools.

Measure the wall and confirm the location to hang the heater. 3 screws and expansion screw nuts contained in the packing box are for hanging the main unit.

Install the exhaust pipe

The exhaust pipe should be inclined downward about 3° in case of rain flow .

An extended pipe is required if the room layout determines. (This part should be individually purchased)

Water/Gas Connecting

LOW PRESSURE REGULATOR FOR LPG (PROPANE TANK GAS)

Attention: Model applicable for LPG should be connected with LOW PRESSURE (2800Pa/ 0.4PSI) regulator. Otherwise the heater will not work well, and some dangers are possible.

Water Distribution

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>