Amolife XYH11RF Remote Control User Manual
- June 6, 2024
- Amolife
Table of Contents
Amolife XYH11RF Remote Control
Remote Control
a.Brief introduction of XYH11RF remote control(W) panel function and install the battery Function analysis of six key wireless key
- S1 key: head up
- S2 key: head down
- S3 key: leg up
- S4 key: leg down
- S5 key: both up
- S6 key: both down
The S1-S6 keys are inching type, release to stop
Please install the battery(U) as shown, pay attention to the battery polarity.
If you can’t slide off the back covers smoothly , use hammer or other heavy
stuff to knock the edge slowly. 
b. If you encountered a power outage, you can install the spare battery on the
motor.
Note: The spare battery can only be used to flat the frame and MUST be
removed after the frame got flat!
Attention: Can only be used in emergency situations!
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC warning:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requir ement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>