Shenzhen Harp Lighting Technology HRP-FL25C-R 433 Remote Control of LED Floor Lamp Instruction Manual
- June 6, 2024
- Shenzhen Harp Lighting Technology
Table of Contents
Function introduction of remote control
| adjust brightness
touch and hold the button the floor lamp will slowly bright
---|---
| adjust brightness
Touch and hold thebutton the floor lamp starts to dim gradually.
WW| Adjust the color temperature
Press this button and the color temperature will slowly drop to 2700K
CW| Adjust the color temperature
Press this button and the color temperature will slowly rise to 6000K
M| RGB MODEL
There are seven modes in total as same as RGB Mode Key
| turn on the lamp turn off the lamp
| Match Code / timer Code
Press and hold both this button and the button of lamp 3 secondsto match
Code.(generally don’t need to do this, it’s already set up previously)
The Match Code can be also used as timer setting, press the code and you see
light flicker once, the light is set to turn off after 1 Hr (please note after
auto turn-off is set, you can only adjust the brightness)
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure
Information The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition without
restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>