VULCAN VUL-MT M Heated Gloves User Manual
- June 6, 2024
- Vulcan
Table of Contents
VULCAN VUL-MT M Heated Gloves
How to install the batteries
Type 1
Outer Zipper Pocket
Type 2
Inside Zipper Pocket
How do I control the heat settings and switch on and off
TYPE 1
TYPE 2
WHAT IS INCLUDED
- A pair of heated gloves
- A pair of 7.4V 2200MAH Polymer Lithium Rechargeable Batteries
- 1pc 8.4V dual battery charger
- 1 piece carry bag
- 1 user manual
HEATING TIME
- High Level: 100% Heat 2-2- 2.5 Hours
- Medium Level: 66% Heat 3-3.5 Hours
- Low Level: 33% Heat 6-6.5 Hours
HEATING AREA
- Heating elements cover the whole of the back of the hand and fingers to the fingers tips
WASHING INSTRUCTIONS
- Remove batteries while cleaning and storing your gloves and close zips before washing
- Use Mild Detergent to clean where required and Air dry lying flat
- Hand wash is recommended for safety
- If Machine Washing is required, it is recommended to wash in a mesh wash bag
- Do not Machine Dry or use Bleach
- Ensure fully dry before use
HOW TO USE
- Charge Up – Fully Charge the batteries with provided charger before using
- Plug-In – Carefully connect the batteries with the power wire located in the pocket
- Press Power button for 3 seconds to switch on with high heat setting and press again to adjust heat modes. To switch off hold power button for 3 seconds until lights not illuminated
- It is recommended to recharge the batteries at least once in every six months to keep useable (If product is not in use)
ATTENTION
- Always remove the batteries from your gloves when charging
- For safety, do not drop, short circuit, or operate under high-temperature conditions
- Ensure product is fully dry following washing/use before reusing and connecting the batteries
- If the device or the battery swells or becomes malformed, please stop using it immediately
WARRANTY
- Lithium-ion batteries, charger and gloves covered for 12 months from date of purchase
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>