Shenzhen Leyusmart Technology F600 TWS Bluetooth Earphones Instructions
- June 6, 2024
- Shenzhen Leyusmart Technology
Table of Contents
F600 instructions
+ LEYU SMART – F600
To connect the device, follow step 1.
Connecting devices
Install F600 in the headset box, open the headset box, then go to Bluetooth settings and select F600.
Click play pause.
Press the left ear twice to decrease the volume, Press the right ear twice to
increase the volume.
Press the left ear three times to jump to the next song, Press the right ear
three times to jump to the previous song.
Long press for 2 seconds to enter the voice assistant.
Headset charging.
F600 needs to be charged in the headphone box, which uses the type-C connector
to charge.
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.